|
Resume alert |
Resumes 51 - 60 of 172 |
Livonia, MI
... 2016 – Present Working on literature review on hybrid laminate with carbon fiber and glass fiber plies at a section of the wind turbine blade Obtained stresses on each ply after application of high values of axial and out of plane torsional loads on ...
- 2017 Aug 29
Southfield, MI
... Increased the efficiency of the system by rise in the average temperature of working fluid entering the turbine. Education Master of Science Industrial Engineering LAWRENCE TECHNOLOGICAL UNIVERSITY Southfield, MI May 2017, GPA-3.30 Bachelor of ...
- 2017 Aug 01
Detroit, MI
... Project work on design and analysis of pelton wheel turbine blades [ 2015 - 2016 ] • Studied and analyzed the blade design using Catia Optimization to increase the performance and efficiency. Defects on Sill Side Panels Of U.V. Body, Mahindra ...
- 2017 Jul 27
Detroit, MI
... system with deformation, observed and compared with the original and commented on the reliabilty of the system Wind Turbine Laminate Design, Wayne State University November 2016 • Developed composite laminate for a blade of wind turbine with a ...
- 2017 Jul 25
Detroit, MI
... Laminate code for Composite laminate design of a Wind turbine blade Sep 2015 - Dec 2015 Developed a hybrid laminate with carbon and glass fiber lamina which would resist high axial loading and edgewise bending moment on a wind blade. Designed a ...
- 2017 Jul 24
Southfield, MI, 48034
... of Wind Energy Vehicle: December 2013 – May 2014 Jawaharlal Nehru Technological University, Hyderabad, INDIA She has a hand on experience in designing and manufacturing a vehicle which works by electrical energy, produced by the turbine due to wind. ...
- 2017 Jul 13
Lincoln Park, MI
... Designer which included the following responsibilities: Contributed designs, packaging & drafting of gas turbine powered generators. Responsible for design, drawing & release of new products. Member of the SAA (Structures, Acoustics & Ancillaries) ...
- 2017 Jul 12
Detroit, MI
... • Successfully designed a 7-layered composite slab which is a part of the blade of the Wind Turbine and applied the calculated Bending and Twisting loads. • Successfully Completed a Project which involved surface modeling of the front bumper of the ...
- 2017 Jul 12
Ann Arbor, MI
... Stability Analysis and Control of a Wind Turbine- Driven Induction Generator Aug’15-Dec’15 Designed a DFIG wind turbine in SIMULINK and using Fuzzy Logic Controller analyzed and controlled the output of the wind turbine. TECHNICAL SKILLS ASPEN EMTP ...
- 2017 Jul 10
Farmington, MI
... method through CATIA V5 • Composite Product Design (CPD) using ply by ply method • composite design on yacht hull and wind turbine blade Assembly of Multi-Plate Frictional clutch in CATIA V5., Wayne state University May 2016- Aug 2016 • Create parts ...
- 2017 Jul 10