Resume

Todd M Purkiss

***** ********* ****.

South Lyon, Mi. 48178

248-***-**** acwy2f@r.postjobfree.com Cell 734-***-****

Objective: CNC Programmer

Education: Northwood University 2004

Business Administration BBA 3.39

Henry Ford Community College 1989

Manufacturing Engineering AA/AS 3.35

Employment: 1998-2016 Numerical Control Service, Inc.

Process Engineering

* Write part processes, Work Instructions, and BOM.

* CNC & CMM programming (MasterCam9)

* Oversee tool room fixture and gage build programs.

* Work with cutting tool suppliers.

* Attend quality meetings. Resolve shop floor problems.

* Cost estimating, Piece Cost, Burden Rate Calculation.

Machine Tool Builder, Plant Retooling Work

* Installation and process prove out of CNC machines.

* Qualify equipment for cycle time, quality, tool life.

* Prepare the new equipment for a 1.67 CPK run-off.

* Attend installation meetings and work with builders.

* Maintain machine installation costs and schedules.

Quality and Gauging Management

* Zeiss CMM Programming, Calypso software.

* I implemented the LK CMM program at General Motor.

* Install quality part probing on all machines tools.

* Purchase, follow up, gages and repairs from suppliers. * Perform GRR on CMM’s, Hard Gages. Manual Calculations.

* APQP, PPAP, 8D, 5S, and Supplier Process Validation.

* Oversee shop floor production SPC sheets.

CNC Training Instructor

* Write the training outlines for ISO 9000 programs.

* I Train Customers on CNC Lathes, Mills, and CMM.

* I teach Ford Trade School ”Basic Machine & Tool Control”

Customers: Automotive: Engine, Transmission, Drive train.

Tooling: Cold Header, Forging Die, Tool & Die.

Government: General Dynamics, M1 Abrams Tank.

Contact this candidate