Welder
Resume:
Marcus L Smith
Longview TX ****1
Objective:
To obtain a full time position as a welder/Pipe fitter/Rigger .
Experience:
Structural Welder/Pipe Fitter
March 2009 - June 2009: Fluor Daniels, Dallas, TX
Performed rigging, welding and pipe fitting tasks to remove and replace heater baskets and to remove and replace expansion joints in the bypass ducts at a Texas Utilities Company (TXU) power plant.
Structural Welder/Pipe Fitter
January 2009 - March 2009: Fluor Daniels, Dallas, TX
Performed rigging, welding and pipe fitting tasks during the process of removing and installing water wall panels & installation and removal of trusses in the boiler to support scaffolding for the interior of the boiler at a Texas Utilities Company (TXU) power plant.
Structural Welder/Pipe Fitter
February 2008 - August 2009: Fluor Daniels, Dallas, TX
Performed rigging, welding and pipe fitting tasks including, grinding, cutting and fabrication to remove and replace hot and cold air blast gates at several Texas Utilities Company (TXU) power plants.
Structural Welder/Pipe Fitter
November 2007 - February 2008: RSO, Hallsville, TX
Performed structural welding and pipe fitting tasks including, grinding, cutting and fabrication as part of power plant maintenance.
Structural Welder
February 2007 - November 2007
Performed rigging, welding and pipe fitting tasks including, grinding, cutting and fabrication for new platforms and grating on the unit, as well as removal and replacement of the hot and cold air blast gates at several Texas Utilities Company (TXU) power plants.
Armament Repairer
June 1999 - February 2007: US Army, Fort Riley, KS
Supervised a team of eight soldiers performing the diagnosis, repair and maintenance of M1A1 tanks. Duties included diagnosis, repair and maintenance of mechanical and hydraulic turrets, the manual gear box, the breach block, and the cradle assembly, removal and replacement of the gun tube, removed and replaced front and rear seals on the gun tube, removed and replaced elevation mechanism and servo component for the elevation of the gun tube, replaced hydraulic and manual drive system & brake system and removed and replaced the race ring requiring pulling the turret. Isolated causes of malfunctions, determined necessary repairs and performed final tests and inspections on these systems.
Education:
Tulsa Welding School, Tulsa OK
June 1997 - April 1998
Received Master Welder Diploma
References are available on request.
Contact this candidate