Engineer Electrical

Location:

United States

Posted:

April 09, 2012

Contact this candidate

Resume:

Carlow Edwards

**************@*****.***

Home 662-***-****

Cell 662-***-****

Education

•Lesley University

Masters of Education, Technology in Education, May 2010

•Macon State College

Bachelor of Science, Information Technology, August 2007

•East Mississippi Community College, Mayhew, MS

Applied Science, Electronics Technology, May 2005

•Community College of the US Air Force

Certificate of Training - Electronic Principles, March 2002

•Community College of the US Air Force

Certificate of Training - Precision Measurement Equipment Laboratory

(Metrology), September 2002

Experience & Training

Metrology Engineer (2001 – 2005) US Air Force

•Calibrate inspection, measurement, and test equipment in the following disciplines - electrical, dimensional, optical, physical/mechanical, chemical - in order to ensure compliance with published specifications

•Served as a calibration technician in the Air Force saving the USA millions of dollars in repair and replacement cost

•Maintain military standards and supported over a thousand pieces of precision equipment

•Preformed Precision Measurement Sciences, basics Statistics , and Technical Writing

•Used electronic schematics for circuit analysis to repair electronic to component level

•Calibrated and documented measurement from AC/DC, time frequency, RF frequency, Physical dimensional lab equipment

Metrology Engineer (2005 – 2007) Kay and Associates Inc

•Worked as a civilian contractor on Air Force Base providing expertise in Metrology

•Maintain military standards and supported over a thousand pieces of precision equipment

•Used electronic schematics for circuit analysis to repair electronic to component level

•Calibrated and documented measurement from AC/DC, time frequency, RF frequency, Physical dimensional lab equipment

Metrology Engineer (Mobile) (2007 – 2008) System Scale Lab Division

•Calibrate inspection, measurement, and test equipment (IM&TE) in one of the following disciplines - electrical, dimensional, optical, physical/mechanical, chemical - in order to ensure compliance with published specifications

•Used electronic schematics for circuit analysis to repair electronic to component level

•Calibrated and documented measurement from AC/DC, time frequency, RF frequency, Physical dimensional lab equipment

•Collect, compile, measure, summarize, and record data gathered during calibration.

•Prepare calibration reports and certificates

•Adapt existing calibration equipment, standards, and techniques to accomplish unique measurements tasks for which they are not principally used

Metrology Engineer (2008-2010) Technical Maintenance Inc

•Manage calibration program for Cooper Tire & Rubber Company - Tupelo Plant

•Create procedures for calibrations perform onsite in order to comply with ISO certification process

•Collect, compile, measure, summarize, and record data gathered during calibration

•Prepare calibration reports and certificates

•Adapt existing calibration equipment, standards, and techniques to accomplish unique measurements tasks for which they are not principally used

•Consult management about ways to improve calibration processes and minimize cost

Field Service Engineer II (2010 – Present) AAI

•Performs technical installation, operation, and maintenance, to include hardware/software maintenance support for Unmanned Air Vehicles (UAVs)

•Provides training and oversee field service activities of lower level personnel.

•Provides liaison activities with customer and engineering staff

•Provides general logistics functions for Unmanned Air Vehicles (UAVs)

•Troubleshoots technical problems and issues and determines technical solutions for Unmanned Air Vehicles (UAVs)

•Schedules, tracks, and monitors tools and test equipment calibration for Unmanned Air Vehicles (UAVs)

Contact this candidate