Electrical Engineer

Professional Synopsis

A highly motivated and creative Electrical Engineer with experience in Electric/wireless Circuits Design, Simulation & Measurement and proficient in computer troubleshooting (hardware & software levels) seeking a challenging full-time opportunity.

Areas of Interest

Electronic/Wireless Circuits Design, Simulation & Measurement

Education

Bachelor of Science, Electrical Engineering 2008

University of South Florida, Tampa, FL

Senior Design Project: Design and Simulation of a 50W Class AB Power Amplifier

Professional Summary

Technical Support Lead, Academic Computing 2005 – Present

Hillsborough Community College, Tampa, FL

Provide computer workstation troubleshooting including hardware/software maintenance and installation, as well as service reporting and following-up.

Support and train clients & employees regarding troubleshooting PC including assistance in Operating Systems (OS) and various software (on-spot or over the phone).

Teaching Assistant Fall 2008 – Spring 2009

Electrical Engineering, University of South Florida. Mentor: Dr. Jing Wang

Instructed an undergraduate class of “Wireless Circuits and Systems Laboratory”.

Taught students the appropriate use of laboratory equipment, and administered and graded quizzes, tests and laboratory reports.

Technical Project Lead, Infrared (IR) Motion Detection Project Summer 2008

Electrical Engineering, University of South Florida. Mentor: Dr. Paris Wiley, P. E.

Designed a pyro-electric crystal based motion detector based on pre-set parameters.

Simulated and validated design to satisfy motion detection requirements of 5 - 15 feet.

Project management and component acquisition based on requirements and deliverables.

Professional & Academic Projects

Designed and implemented a 50W Class AB Power Amplifier and a Power Supply for the device. Observed enhanced behavior resulting in an output amplification of up to 60W.

Designed, simulated and validated a pyro-electric crystal based Motion Detector to satisfy motion detection requirements of 5 - 15 feet.

Created a matching circuit comprised of a quarter-wave, microstrip matching-section, a lumped element (surface mount) resistor, and an RF short with a center frequency of 2.0 GHz.

Designed and assembled RF circuits, including Low-pass Filters (LPF), Highpass Filters (HPF), Bandpass Filters (BPF), Notch Filters and Mixers. Observed and gained an understanding of parasitic effects and performance principles of various RF circuits.

Synthesized, simulated, and assembled a bench-top antenna system that was preconfigured to receive a certain signal and up/down converted it to receive a designated signal.

Relevant Courses

Electronics I & II RF/MW Wireless Circuits I & II RF/MW Measurements

Calculus I, II & III Physics (w/Calc.) I, II & Lab Engineering Statistics

Electronic Material/Semiconductors Engineering Economics C++

Certifications & Memberships

Institute of Electrical and Electronics Engineers (IEEE) 2007 – Present

Society of Women Engineers (SWE) 2007 - Present

Occupation Safety and Health Administration (OSHA) Certification 2008

Languages & Skills

Orcad PSPICE Agilent ADS AutoCAD MathCAD

LabView Simulink C++ Programming

Standard Lab Equipment (DMM, O-scope, VNA, SA, Signal Generator etc.)

MS Office Suite (2003, 2007 & 2010) Windows OS

Full fluency in English & Bangla Oral fluency in Hindi & Urdu

Contact this candidate