Quality Engineer

Mary Pool

***** **** *** *******, ** ***** 662-***-**** **********@*******.***

Objective: To obtain a position that will enable me to utilize my experience in Quality Assurance, Automotive Manufacturing, and Electronics and Screw Machine background.

Professional Summary

Experience 19 years of Quality experience in the manufacturing of Storage System, Automotive Seat Frames, Armor Vehicles and Screw machines. Skill in Automotive production PPAP, FMEA and Control plan for automotive seat fastener and seat frames, Gage R&R, SPC study, corrective action 8D.

2008-Present Pantheon (BAE System) Atlanta, GA

Quality Supplier Engineer

* Responsible for PPAP submitting for Military Vehicles (Army).

* Participate in MRB meetings concerning corrective actions and improvement issues.

* First article layout for armored vehicle frame

* Supplier Audits per TS16949

* Responsible for customer and supplier Corrective Action (8D)

* Manage 15 suppliers for Corrective action, PPAP

2008-2008 Camaco LLC Columbus, NE

Quality Engineer

* Responsible for Corrective Action for Ford Automotive Seat Frame.

*Audit Poke Yoke systems on Weld Robots

*Responsible for submitting Automotive Seat PPAP's

*Participate in APE meetings concerning 8D’s and improvement issues.

*Audit Production Control Plan per TS16949

2001-2007 Integrated Logistics Solutions Memphis, TN

Quality Specialist

*Participate in development of FMEA and control plan PPAP’s documents for Automotive Fasteners.

*Responsible for Supplier Quality Improvements and verifying Poke-Yoke devices put in place to eliminate quality issue and improve on the process.

*Responsible for customer and supplier 8D (Corrective action) visit customer and supplier sites to determine how the issue occurred.

*Train Quality personnel and create work instructions.

2000–2001 Security Signals Inc. Cordova, TN

Chief Quality Technician

*Responsible for first article inspection for Department of Defense per Military ISO 9000 standards Fastener Manufacture.

*Responsible for testing of heat treated screws case depth using micro hardness testers

*Monitor and generate SPC data reports, verify operator’s mistake proofing system for Fastener and gears.

1993–1999 Richards Wilcox Aurora, IL

Quality/Field Service Engineer (Promoted from QA Tech)

*Installed and supervised insulation of vertical and horizontal storage system mechanical and low voltage control panel.

*Developed test procedures for electrical and mechanical equipment for vendor and quality department.

*Investigated customer complaints for manual and electrical storage system, visit customer site to correction system issues.

*Technical support for fabrication set ups, sale personnel, customer and installer.

*Participated in Material review board meetings (for Non-conforming parts).

*Inspected fabricated steel parts, machine shop, power coated paint system and raw stock steel.

Education

2005-2007 Southwest College/ University of Memphis Memphis, TN

Manufacturing Engineer, Project Management I and II,

1988-1989 Memphis Institute of Technology Memphis, TN

Associate Degree in Electrical Technology.

Certificate and experience

Certificate in APQP, FMEA PPAP, project management

Certificate in QS9000 Lead Auditor.

Certificate in insulation and servicing of Material Handling and Storage systems vertical and horizontal.

Experience in micro hardness, motor control, powder coating paint and circuit board testing

Reference: Available upon request.

Contact this candidate