Fiber & RF Tech Lead Field Installer
Resume:
Zobek Rodriguez
**********@*****.***
Riverside, Ca. 92508
WORK EXPERIENCE l
QUALTEK WIRELINE / Vista, Ca.
*/**** – Current
Title; Laborer ll
Roles & Responsibilities
• Trenching through paved streets with a Ditch-Witch micro trencher to install & run fiber.
• Installing fiber hand hole boxes in the ground.
• Running fiber conduits.
• Testing fiber tubes with compressor & pressured air.
• Core-Drilling out pot holes to check depth of utilities.
• Vacuuming & pressure washing trench behind excavator to remove excess rock & debris.
•Operating Jack-hammer through concrete.
WORK EXPERIENCE ll
UNIVERSAL WIRING / La Habra, Ca.
01/2023 – 07/2023
Title; Lead Tech/ Fiber & RF tester
Roles & Responsibilities
• Performing OTDR/IOLM & scopes on fiber for Verizon, Dish & TMO installs.
• Testing & Troubleshooting RF lines & systems with Anritsu test gear.
• Installing 5G & upgrading 4G radios & antenna systems.
• Swapping out arrays, adding structural support for collar mounts.
• Daily updates & reports to supervisor.
• Setting RETs.
• Close out photos, Alignment tool reports, labels.
WORK EXPERIENCE lll
WES-TEC INC. / Aliso Viejo, Ca.
01/2013 - 11/2022
TITLE; Lead Tech from 2016 – present.
ROLES & RESPONSIBILITIES 2013 - 2022
• Managing a 2–4 man crew, setting RETs, performing RF & Fiber testing, crane pick operations, close-out photos, job walks, trouble-shooting alarms & outages, landing power in various terminals for both A/C & DC currents, training new hires, reading Cd’s & RFDS’s, new installs & technology upgrades for Low & High band frequencies.
• Experience on lattice, transmission & guyed towers (up to 300’), mono-poles, mono-trees, billboard signs, temp sites, water tanks, rooftops, controlled descend over the sides of structures.
• Cell site decoms, removal of poles, towers & shelters.
• Acquainted w/ various carriers, Verizon, AT&T, T-Mobile, & Sprint. Log-in, check-out protocols.
• Travelled to the states of Georgia / Alabama to set up Wes-Tec East.
• Power & fiber connections/terminations inside Raycaps/ power plants.
• Prepping RF jumpers, swapping out array structures, running hybrid, coax & fiber home runs, mounting antennas & RRU’s, installing & decommissioning cabinets, familiarizing color codes, grounding, conduit & cable tray/ladder raceways, labels, GPS installs, RET charts, worked w/ DAS networks on multiple stadiums installs (SOFI, STUB-HUB, ROSE BOWL etc. )
CERTIFICATES/ TRAINING COURSES
• RF Awareness 2022 - Present
• Adult CPR BLS “A” / Standard First Aid 2022 – Present
• Tower Climbing Safety & Rescue 5/13/22 - Present
• National Wireless Safety Alliance / Telecommunications Technician TTT-1 3/31/22 - Present
• All-Access / Aerial Work Platform Safety Course 2022 – Present
• NATEC International Safety Inc. / Traffic Control Coning & Flagging 6/11/21 - Present
• JMA Connector Training 2021
• OSHA-30 2018 - Present
• ANRITSU – Site Master Line Sweep Certification 2018
• ANRITSU - Pim Master Certification 2017
WORK EXPERIENCE lV
INDEPENDENT CONTRACTOR TELECOM SO-CAL 6/2011 - 12/2012
TITLE; Aerial Tech
ROLES & RESPONSIBILITIES;
• Running coax, power & fiber. Mounting Antennas, prepping RF jumpers, grounding, supports, cable tray runs, conduit runs. Learning Telecom in general.
WORK EXPERIENCE V
THE INDUSTRIAL COMPANY (T.I.C.)
824 Poplar St. Elko, Nv. 89822
7/2008 - 3/2010
TITLE; Electrical Apprentice
ROLES & RESPONSIBILITIES;
4/2009 - 3/2010
• Took part in the construction of a 10-mile-long overland conveyor system For Barrick Gold at Cortez Hills Gold Mine.
• Ran power, fiber, lighting & cable tray along the conveyor through 10-miles of mountain.
• Installing junction boxes, splicing & landing 120-240 volt circuits.
• Cadwelding & ground rods. Jack hammer drilling through rock.
7/2008 - 4/2009 Stillwater, Nv.
• Took part in the construction of a Triple Hybrid Geothermal Power Plant.
• Running & pulling wire for high voltage transmissions.
• Prepared & assisted terminating 69 KV kits.
• Custom fabricated cable tray & cable tray support systems.
• Running & terminating 795 ACSR wire to transformer.
• Part of the team responsible for the wiring circuits for DCS alarm & SCADA control wiring from main control room to the 15-Megawatt geothermal generating units.
CERTIFICATES/ TRAINING COURSES
• MSHA-Part 46 / 2009
• TIC Corporate Training Center, (Steamboat Springs, Colorado) /
400 hour electrical & mechanical studies for electrical apprenticeship / 2009
EDUCATION
LA SIERRA HIGH SCHOOL 2002-2006
4145 LA SIERRA AVE. RIVERSIDE, CA. 92503
• High school Diploma 2006
Contact this candidate