Electronic Technician
Resume:
Yunus Mansur
Tel# 647-***-****; 647-***-****
E-mail: **********@*****.***
Career Objective: Seeking a position as a valued member of your company as RF/Electronics Technician /Technologist.
Relevant Skills
Solid working experience in microelectronics assemblies, test and troubleshoot prototype circuits
Sound knowledge of RF Theory and electrical system
Familiarity with Spectrum Analyzers, Signal Generators, Network analyzers (VNA, PNA)
Able to read and follow schematics and wiring diagrams
Ability to troubleshoot and tune complex RF high power delivery systems to the module level
Ability to use general knowledge of Microwave and RF circuits theory
Enthusiastic, task focused, self-motivated and able to work under minimal supervision
Job Duties
Motorola solutions Concord December 2022-Present
Test engineering Tech II
Test, tune and repair of DVR and VRX for UHF VHF. Testing unit for temperature stress test at -30 C to 60 C and verify performance using spectrum analyzer. Check RF o/p power and measuring spurious using HP test. Resolving RSSI failure for Repeater.
CPI Georgetown November 2018 –November 2022
Electronics/RF Technician
Medical Department:
My job description comprises: Test X-Ray generators, Test PCB boards and troubleshooting using Oscilloscope and multimeter/LCR meter. Calibrate x-ray generator using auto tube calibration. ATE cycle.
Microwave Department:
My job description comprises: assembling, testing (auto and manual at cold, RT and hot), tuning of Phase and gain of Booster (Combiners & Arrays), Programming of M - C Board.
Nanowave Technology, Etobicoke September 2014 – November2018
RF Technician
My job description comprises: assembling, testing, calibrating, tuning (HMIC power amplifiers products) and preparing test data for engineering and documentary work.I worked with entire project cycles from receiving electronic devices to processing, testing (ATP and Pre-seal test) & tuning, assembling, documenting and finishing up the unit (transceiver) for shipment. Some of the tasks include unit testing at different temperatures: -55 C, room temperature and 75 C. There is also assembly/disassembly of devices, calibration of transceiver, troubleshooting of PCB, Detectors, Power Amplifiers, Splitters, Drivers and whole units (including RMS units). I have a proven knowledge of Function Generators, Signal Generators, Oscilloscopes, Spectrum Analyzers, Network Analyzers (VNA, PNA) etc. I can read electronic/electrical circuit drawings and apply theoretical principles. Also, I completed soldering training as required.
Educational Qualifications
Advance diploma in Electronics Engineering April 2014
Technology (Three semesters with 3 GPA), Centennial College, Canada
Bachelor of Science with physics (Electronics). May 1988 Gujarat-INDIA
Master of Science with Physics (Material Science) May 1990 -India
REFERENCES
Available upon request
Contact this candidate