Machine Operator North America

Joseph Tumlin

**** ******** ******,

Flowery Branch, GA 30542

Phone: 706-***-****

Email: *************@*****.***

Employment History

**/**** – Siemens Mobility

Present

Inspect Used Motors And Small Parts For Damage

Build New Motors

Tear Down And Rebuild Used Motors With New

Bearings, Bolts, Gaskets, Grease, And Plastic Hardware Paint Motors, Balance Rotors, Place New Bushings In MotorsApply Metal Anti-Rust Inhibitor On Exposed Bare Metal

Place New Nameplate And Ground Plug On Motors

Package And Prepare Motor For Shipping Back To Customer In Crate, Use Micrometers, And Depth Gauges To Insure Couplings And Other Small Parts On Motor Are Within Tolerance, Use Volt And OhmMeter To Check That Voltage And Ohms Are Correct Inside Motors

04/2023-04/2024 Machine Operator gum Puller

MARS WRIGLEY NORTH AMERICA, Flowery Branch, GA

Ran Machine, Pulled Gum

02/2023-

04/2023

Parts Inspector

Surge Staffing/Stratosphere Quality, Flowery Branch, GA Inspected Parts For Discrepancies, Blemishes, or Damage!

02/2022-

09/2022

Assembly line worker

Kubota Manufacturing of Amer, Gainesville, GA

Maintain or exceed necessary production rate to prevent line from shutting down. Assemble mower decks as they move down the line. Ensure correct parts are added to the right mower deck. Monitor part inventory at line and replenish as needed. Maintain a clean organized and safe work area.

04/2012-

05/2021

KITCHEN ASSOCIATE

DOC, Morgan, GA

Train new employees. Cleaned, cut, and cooked meat, fish and poultry. Bake bread, rolls and other pastries. Cook required foods according to daily menus, number of required portions, special dietary and nutrition restrictions. Apportioned and served food to facility residents, employees and patrons. Cleaned and inspected galley equipment, kitchen appliances and work areas to ensure cleanliness and functionality.

08/2006 -

01/2012

McClain International Heico Aerospace Corporation College Park, GA Raw Ring Fabricator Set up and operate fabricating machines, such as press breaks, rolls, shears, flame cutters, and drill press. Located and marked bending and cutting lines onto the workpiece allowing for stock thickness, machining and welding shrinkage and distortion. Verified conformance of work piece specifications by using measuring tools that included micrometers, calipers, tape measures and machining squares.

Education History

Automotive Technology

High School Diploma

Technical High School of Carroll County, Carrollton, Ga

Contact this candidate