Electrical Systems Garden Grove

Mark Gaxiola

*** * ****** ***

Hemet Ca, ****3

Phi 951-***-****

********@*****.***

Work Experience

TRUE FORM INDUSTRIES, CERRITOS, CA

Shipping & Receiving / Assembly, May 1995 — Jan 1999

Count finished products to determine if product orders are complete.

Mark or tag identification on parts.

Tie products in bundles for further processing or shipment, following prescribed procedures.

Prepare raw materials for processing.

Read gauges and charts, and record data obtained.

Mark or tag identification on parts.

Packaging part to ship, reading hardness & conductivity from heat treat, drilling,riveting, blueprints

smylars

GARDEN GROVE ELECTRIC, HUNTINGTON BEACH, CA

Apprentice, Jun 2003 — Dec 2005

Measure, cut, and bend wire and conduit, using measuring instruments and hand tools.

* — Strip insulation from wire ends, using wire stripping pliers, and attach wires to terminals for

subsequent soldering.

Construct controllers and panels, using power drills, drill presses, taps, saws and punches.

Maintain tools, vehicles, and equipment and keep parts and supplies in order.

Install copper-clad ground rods, using a manual post driver.

Perform semi-skilled and unskilled laboring duties related to the installation, maintenance and repair

of a wide variety of electrical systems and equipment.

Break up concrete, using air hammer, to facilitate installation, construction, or repair of equipment.

Dig trenches or holes for installation of conduit or supports.

— light installer

STRETCH FORM CORPORATION, PERRIS, CA

fabrication, Sep 2012 — Oct 2015

* Position, align, fit, and weld parts to form complete units or subunits, following blueprints and layout

specifications, and using jigs, welding torches, and hand tools.

Locate and mark work piece bending and cutting lines, allowing for stock thickness, machine and

welding shrinkage, and other component specifications.

Study engineering drawings and blueprints to determine materials requirements and task

sequences.

Mark reference points onto floors or face blocks and transpose them to work pieces, using

measuring devices, squares, chalk, and soapstone.

Remove high spots and cut bevels, using hand files, portable grinders, and cutting torches.

* Position, align, fit, and weld parts to form complete units or subunits, following blueprints and layout

specifications, and using jigs, welding torches, and hand tools.

* routing parts off tooling

Contact this candidate