Tiffany Thomas

Machine Operator - US Smokeless Tobacco

Nashville, TN 37203

adxl76@r.postjobfree.com

1-256-***-****

To obtain a position where I can utilize my training, experience, and customer service and soldering skills

to promote advancement and growth with and for your company. Work Experience

Machine Operator

US Smokeless Tobacco Co - Nashville, TN

January 2017 to Present

Clean and sanitize the machines to process the tobacco. Check the production schedule for orders. Prepare to process the order, check to make sure the material and tobacco matches the production schedule before using. Once verified by the BUL/ supervisor and QA proceed to run each order. Team Leader

Palco - Huntsville, AL

January 2011 to January 2017

Provide the employees with parts, tools and paperwork to do their jobs, answering the phone and calling customers about their orders. Building spread sheets for weekly task and pulling part from stock and typing in order and getting them ready for shipments. RMA Processer / Data Entry

Palco - Huntsville, AL

September 2010 to January 2011

Recording all the PC board information on a spread sheet, sending it to the customer requesting a RMA numbers for the PC boards, once the customer

provide the RMA I transfer the information to the assigned number and release the S/N check. Receiver / Data Entry

Palco - Huntsville, AL

September 2007 to September 2010

Responsibilities included, but were not limited to, receive PC boards and inspect them for damage, missing etc. Upgrade to the highest rev. if needed, Answering the phone and put the customers information into the computer, check order status and ship out orders. Hand Brazing

Tru Line Manufacturing - Decatur, AL

August 2006 to September 2007

Clean fittings and then put solder rings in them, then put them both on a tub and use a torch and heat the tub and bottom of fitting until the ring melting and press the fitting down on the tub, put the tub in the water, after it cool inspect the braze joint for open joints and etc.

Cell Leader and Quality Inspector

Mitchell Plastic - Huntsville, AL

January 2005 to August 2006

I provide the cells with documentation, pens, forms, knives, and other supplies as needed. I ensured that the work instructions are being followed. I also perform first off, in process, and final inspection of production parts, using gauges and fixtures including SPC studies.

Assembler and Machine Operator

Mitchell Plastic

September 2004 to January 2005

I inspect parts for flash contamination. I also trimmed high gates and break parts from the runner. SMT Operator

Benchmark Electronics - Huntsville, AL

March 2002 to September 2004

256-***-****

Post-wave Touch-up Soldered

Responsible for soldering components onto PC boards, inspecting them for bridges, missing parts, etc.

Education

diploma in which I my

J.O. Johnson High School

1998

Additional Information

Qualifications:

Have over ten years of industrial, assembly, soldering and quality inspection experience and I have taken the hands on and book soldering test and hand brazing test.

Contact this candidate