Control system specialist engineer
Resume:
Gamal Morad I&C c.v Page * of *
Gamal Shaaban Senhabe Morad
Date of Birth 18/1/1983 Mob # +966*********
Nationality Egyptian Mail *******@*****.***. *******@*****.***. Position
I&C Senior
Engineer Linkedin
https://www.linkedin.com/in/gamal-morad-
32988160
Current
Location Saudi Arabia Skype *******@*******.***.
Marital Status:
Married,
3 children
Years
Experience 17 year
Educational Qualifications
Name of School/College/ Year Attended Qualification University/Institution From To Certificate/Diploma/Degree Menoufia University 2000 2005 B.Sc. Electronic Eng. Training Courses
Fundamental electrical circuit DCS GE MKVIE Maintenance and Troubleshooting PLC SIEMENS S7 – 400/ 300 / 200 GE TCS (MKV,MKVI,MKVIE ) PRIMAVERA P6 SCADA SYSTEM RS VIEW 232 and SIEMENS WINCC Work Experiences (Start from current)
1. Name of Company Position From To
Target Engineering Construction
Control System Specialist
(approved Aramco)
9/2022 Present
Client: Saudi Aramco, Northern Area Oil Operation Capital Progress Management Project: UPGRADE WATER DISPOSEL FACILITY – QATIF (BI-10-05237 ) Brief Job Description :
Technical Support for Engineering Team for design of project control systems:
- DCS DELTA V - ESD Rockwell - VMS GE (Bentley Nevada).
- Check correspondence of C&E, LOGIC, CONTROL NARRATIVE with equipment vendor requirement and site condition.
Review and comment new logic related to project on DCS/VMS/ESD
Review modification required on old Control system
Lead FAT activity of control systems (ESD / DCS/VMS)
Installation and SAT (site acceptance test) plan Prepared with requirement.
Lead SAT activity of control systems (ESD / DCS/VMS) 2. Name of Company Position From To
PETROJET.
Control System Specialist
(approved Aramco)
6/2020 8/2022
Client: ARAMCO, Ras Tanura Terminal South, DCS UPGRADE CONTROL SYSTEM Brief Job Description :
approved Aramco as Control System Specialist engineer.
Check and review old control system TDC3000 DCS component Hard ware, IODB, and logic.
review design packages IODB, ILD, PFD, P&ID ….
Check and review engineering design of Honeywell DCS C300 (IODB, LOGIC, ILDs, wiring, Control Narrative ...)
Performing and mange Factory Acceptance Test (FAT) and Site Acceptance Test (SAT) Honeywell Experian DCS System C300
Compare & check DCS logic (TDC3000 old DCS SYSTEM with new logic on C300 DCS SYSTEM)
Check and review Cut over plan between old and new DCS system (hardware & software)
Team Leader DCS hardware cutover and rectify hardware problems.
Team Leader DCS C300 Control System: installation, Loop Check, Test & commissioning.
Contractor lead for Cutover OMSS system to PBM system.
Review and update PFD &HMI for PBM system.
Gamal Morad I&C c.v Page 2 of 4
3. Name of Company Position From To
Asas Aljood Gen. Cont. Co. Project Manger 12/2019 6/2020 Client : ARAMCO, Riyadh Refinery, COMPRESSOR OVERHAULING Brief Job Description :
Managing and organizing the various people working on the project
Control Project scope and claim of variations when required
Provide technical support for electrical and control team during project.
Prepare and select qualified man power
Technical and commercial meeting with client (Aramco)
Lead Startup, Test and commissioning project equipment’s and systems.
Calibrate and test all control devices related to compressor (vibration, pressure, temperature, flow …) 4. Name of Company Position From To
Tamkeen Advanced Company Testing and Commissioning Manger 7/2017 8/2019 Client : Saudi Electricity Company, Gas Turbine, Brief Job Description :
Review Re engineering control system to replace GE mark 5 turbine control system by Mark 6E control system.
Installation, Edit & Modify DCS panel Soft Ware and hard ware.
Test & commissioning GE MKVIE TCS, DCS, excitation system
Review, test & commissioning MCC Panels,480-volt switch gears and test operation scheme
Review, test & commissioning Gas Turbine Components (IGV, BYPASS Valve, Fuel Stop & Recirculation valves, Speed &Vibration, DC system, Fuel system, Cooling system, Water Wash System)
Review, test & commissioning firefighting system (CO2 system, FM 200 system, Deluge system ...) with main DCS control panel.
Lead project FAT (GE Dubai) & SAT (at najran power plant).
Lead tests and commissioning for GAS Turbine (Start up, FSNL, Base load)
installation and test new control panels for Sump pits & Air cleaning system.
check logics according to process and modify it with GE TA.
Hard ware replacement and work on software to make required modification.
Trouble shooting for different problems that can appear on control system during Test & Commissioning (signal need adjusted, ground fault, adjust alarms and trip, hard ware, …)
Calibration IGV, TORQUE CONVERTER, Transmitters, switches
Installation Excitation system EX2100E & test, commissioning 5. Name of Company Position From To
Saudi Electricity Company Technical Support Engineer 2013 2017 Brief Job Description :
Test and commissioning with Hyundai vendor different control system ( Alspa turbine control system & DCS ovation control ) for steam boiler devices at shuqiq steam power plant (4unit *670MWATT) from 2/2017 to 7/2017.
Follow up calibration of all instrument and control valves for boilers and turbines.
FROM 6/2013 to 1/2017 work at najran Gas Turbine power plant (Gas Turbines 7 unit *60MW) for below :
Technical support Engineer
Specialist Engineer for trouble shooting different electrical and TCS control system (MKV, MKVI, MKVIE)
Specialist Maintenance & trouble shooting Engineer GE MKVIE DCS system (software and hard ware)
Lead installation and test Supervision new water treatment plant project
Supervising the implementation of short and long-term projects.
Proposal and implementation of various improvements to old control systems Gamal Morad I&C c.v Page 3 of 4
6. Name of Company Position From To
Egyptian Electricity Company Instrumentation and control engineer 2007 2013 Brief Job Description :
DCS Maintenance engineer at El kurimat Power station 2 unit *627 MW boiler and steam turbine.
CM &PM for different instrumentations inside plant (transmitters, switches, valves, flam scanner, flow meter, vibration, dampers, temperature…)
Calibration different instrumentations inside plant.
Maintenance and modification DCS system Emerson WDPF (loop check, logics, alarms, trips.
Support operation during urgent work process.
Supervision MI & CI shutdown outage.
7. Name of Company Position From To
Egyptian Ministry of DEFENSE E&I Engineer 2006 2007 Brief Job Description :
Maintenance E&I engineer at El Nasr company for intermediate chemicals, Aluminum Sulfate Plant, Sulfuric acid plant,
PM & CM Maintenance 480-volt switch gear inside plant
PM & CM Maintenance different control systems inside plant.
Maintenance and calibration different instruments inside plant (transmitters, control valves, switches, vibrations,)
PM&CM for DCS ABB control system.
PM&CM for different electrical and control systems inside water treatment plant. Gamal Morad I&C c.v Page 4 of 4
References:
E. Nawaf Haif
Project Manger PMT, Saudi Aramco Company
TEL : +966*********, Mail: *****.****@******.***
E. Syed Qadri
Honey well DCS TEAM LEADER,TEL :+966*********
Mail : ****.*****@*********.***.
E. Naresh Kumar
Honey well DCS TEAM LEADER,TEL :+966*********
Mail : ***********.*****@*********.***.
E. Adnan Dar Technical Manger, TEL: +966********* Mail : *****.***@*********.***
E. Mostafa EL shaaer
GE Technical Manger,TEL :+966*********.+966*********, Mail : *******.********@****.***.
E. wael Zakzok
GE TA, TEL : +966*********, Mail: ****.*******@****.***
E. Mohd Shafiuzzaman
GE TA, TEL : +966-********* Mail : *****.****@****.***
E. Ali AL Basher
General manger at Saudi electricity company, Najran power plant,gas turbine Tel: 009***********, Mail : **********@**.***.**
E. Aidah Okel
Technical manger at Saudi electricity company, Najran power plant,gas turbine Tel : +966*********, mail : ******@**.***.**.
E.Gamal Arafa
General manger at El koremat power station, Egypt, Tel: +201********* .
E. Mahmoud hendawy
General Manger, Asas Aljiood Co. and Previously SAECO company & Tamkeen advanced company TEL : +201*********, Mail: *********@*****.***
E. Mohammed Taha
Project Manger, Petrojet company
TEL : +966*********, Mail: *****@********.***.** .
E. Mohammed Walid
Project Manger, Petrojet company
TEL : +966*********, Mail: *.*****@********.***.** .
Contact this candidate