Joseph P. Wukawitz Residence 714-***-**** **** S. Sundance Dr. Cell 714-***-****
Anaheim Hills, Ca. 92808 _E-mail Address: aducup@r.postjobfree.com
Professional Objective
To obtain a position within an organization where a motivated, accomplished and organized professional in the world of machining is needed.
Highlights of Skills and Knowledge:
oKnowledge with Deckel Maho 5 axis 2 Pallet Mill
oKnowledge with Fadal 2 axis with 4th axis Mill.
oSome Conventional Mill and Lathe.
oSome Knowledge in Programming and Applying Tools to the Job.
oKnowledge in Reading and interpreting Blue Prints.
oKnowledge in Computers.
oKnowledge with exotic materials: inconel, stainless, titanium, magnesium, aluminum.
oSome Knowledge in deburing.
oSome Knowledge in installing inserts.
oKnowledge in Sharping, and Bull nosing Endmills and other tools.
oDesigning Fixtures and Form tools.
oPlanning.
oISO9000 and AS9100 experience
Professional Experience:
Machinist for Martinic Engineering Inc. March 2006 – Present
10932 Chestnut Ave.
Stanton, Ca. 90680
714-***-**** Ext. 713
Responsibilities are to, Set-up and run a DMU 70 evolution Deckel Maho 5 axis
Mill with Mill Plus Control. Set gages; check parts while machining the parts. Keep machine clean and oiled,
clean surrounding area. Help the other machinists if needed. If new job, program, write planning and design fixturing and form tools, and order tools needed.
Machinist for Boeing Phantom Works Sept. 2005 - 2006
Irvine, Ca
Responsibilities were to Set-up and run 2 axis Fadal Mill with 4th axis with a Fanuc control and Set-up and run Conventional Mill operations as needed.
This was a research and development operation.
Machinist for Martinic Engineering Inc. March 1998 – 2005
10932 Chestnut Ave.
Stanton, Ca. 90680
714-***-**** Ext. 713
Responsibilities were to Program, Set-up and run a Deckel Maho 700 2 Pallet 5 axis
Mill. Set gages; check parts while machining the parts. Keep machine clean and oiled,
as well as the surrounding area. Help the other machinists if needed. If new job, program, write planning and design fixturing and form tools, and order tools needed.
Machinist for American Electronics Inc. March 1978 - 1998
1600 E. Valencia Dr.
Fullerton, Ca. 92631
Started as a trainee, running a Hydraulic Profiler cutting materials, inconel, stainless, aluminum, titanium, magnesium.
Promoted to NC Mill (tape reader)
Bandit Control CNC Mill, GE NC Lathe
Promoted to Forman/Machinist in 1997
Did some quoting, ordering of materials, inserts, outside processing, inspection, and final buy off with customer.