Controls Technician, Electronics Technician, I/E
Resume:
CONTACT
***********@*****.***
Stewartville, MN 55976
HIGHLIGHTS
Journeyman A Electrician License State of Minnesota
Instrument Technician
Electronics Technician
Proficient in electrical repair
ISA Member
NFPA Member
NCCER Certified
Computer Skills
excellent Troubleshooter
Voice, Data, Fiber-optics, Fire alarm installation
EDUCATION
2015
Associate of Applied Science - Industrial Automation, Controls and Networking
Wisconsin Indianhead Technical College
New Richmond, WI,US
This program prepares the student to be employed at the technician level or higher on computers, industrial computer networks, programmable logic controllers (PLC's), and instruments. PLC,s are often the heart of the control portion of the manufacturing process. The student will have both classroom and hands-on laboratory instruction with several systems to help students understand computer and PLC interfacing, control systems, network installation, and administration.
2015
Certificate - Advanced Automation Controls Specialist
Wisconsin Indianhead Technical College
New Richmond, WI,US
Smart Instruments, Industrial Networks and Communication Busses, Supervisory and Distributed Control Systems, Industrial automation case project, Advanced PLC programming and interfacing.
2015
Certificate - Instrumentation and Controls System Specialist
Wisconsin Indianhead Technical College
New Richmond, WI,US
Electricity 1, Introduction to process control, Industrial power electronics, process control and instrumentation, PLC programming and interfacing, Industrial motor control and Pilot devices.
2015
Associate of Applied Science - IT Network Techncian
Wisconsin Indianhead Technical College
New Richmond, WI,US
This program prepares the student to be employed at the technician level or higher on computers, industrial computer networks, programmable logic controllers (PLC's), and instruments. PLC,s are often the heart of the control portion of the manufacturing process. The student will have both classroom and hands-on laboratory instruction with several systems to help students understand computer and PLC interfacing, control systems, network installation, and administration.
2016
Special Boilers License for Minnesota - Steam Engineering Low and High Pressure
Riverland Community College
Austin, MN,US
Steam Engineering- Low and High pressure Boilers.
SUMMARY
Technical college graduate with 31 years in the Electrical/Instrumentation, Electronics, Automation Controls Technician in the service and repair industry. 16 years New Construction installation Contracts and 15 years Maintenance in the above fields. Repair Technician committed to providing excellent service to clients in manufacturing sites. Highly specialized in automated machine and control systems repair. Hardworking and flexible.
ACCOMPLISHMENTS
Honorable Discharge from the United States Navy
Airplane Electrical Technician for Mcdonnell Douglas Aircraft.
I wired up the first 7 C-17 Airforce Cargo jets ever made
1st flight line Electrical Technician
Graduated May 15, 2015 with honors with an Associates in Applied Science degree
Supervised a team of more than 6 electrical technicians.
Completed 10 hours of advanced OSHA training in jobsite safety
MSHA training Hibbing Community College
First Aide Training with extensive MSHA Training for sand Plant/Mines
Assisted in training over 100 new service technicians. In various Refineries throughout California, Texas, Louisiana
Instrumentation and Electrical for 18 platforms in the Gulf of Mexico for Coastal Oil & Gas
Special Boilers License For Minnesota
EXPERIENCE
Journeyman Electrician
Egan Electric Rochester, MN
05/2022 - 05/2022
Dug trenches and created holes to pull conduit and install supports.
Run Home-runs for power, Lighting, Emergency Lighting
Talented Journeyman Electrician with expertise in layouts, installations and rough-in work. Familiar with fixtures and customer preferences. Methodical professional with meticulous attention to detail.
Journeyman Electrician
Newtron Group Baton Rouge, LA
07/2021 - 04/2022
Kept work areas clean, neat and free of hazards.
Seasoned Journeyman Electrician bringing 32 years' experience working on existing building systems as well as new construction.
Increased project completion time, employing best practices when installing and maintaining cableways, conduits and control systems.
Install Cable trays and Bonded completely.
Journeyman Electrician
Parsons Electric Waseca, MN
03/2021 - 07/2021
Run underground PVC pipe 3/4" to 6". Install to print and tolerances for vaults and Transformers. Install Temp power for all the other trades. Lock-out-tagout. Install lighting and receptacles on the roof for maintenance purposes for the equipment on the roof. This is a Con-Agra job. Install Controls, Lighting and power. The job is on going.
Built controllers and panels to complete system installations.
Worked with building management to optimize system performance.
Journeyman Electrician
Baker Electric Electrical Contractors Des Moines, IA
07/2020 - 01/2021
Microsoft New Installation Data Center
Dug trenches and created holes to pull conduit and install supports.
Kept work areas clean, neat and free of hazards.
Increased project completion time, employing best practices when installing and maintaining cableways, conduits and control systems.
Working from prints to install conduit, Grounding, Cable tray.
Measurements and take-offs had to be precise before the area was backfilled
All measurements were Trimbled to make sure all the conduit was below the cement.
Journeyman Electrician
Adair Electric Rochester, MN
06/2019 - 03/2020
Traced and diagnosed electrical malfunctions using hand tools and test equipment.
Proficient Journeyman Electrician adept at mentoring junior electrical workers and training on correct safety procedures, building codes and finishing strategies. Motivational leader able to solve routine and complex problems with resourceful and experienced approach.
Talented Journeyman Electrician with expertise in layouts, installations and rough-in work. Familiar with fixtures and customer preferences. Methodical professional with meticulous attention to detail and efficient manner.
Dependable electrical installer able to follow instruction and interpret blueprints. Strong troubleshooting and diagnostic abilities.
Examined and tested electrical systems to locate loose connections or other faults and make proactive repairs.
At MAYO Clinic Methodist Hospital/Gonda Building
Maintenance Electrician
WestRock Papermill St.Paul, MN
03/2019 - 06/2019
troubleshoot and fix or correct all Electrical and controls problems associated with the 4 paper mills that need to keep running.
PLC's, VFD's, lighting, power and controls, motors. Anything Electrical or instrumentation was corrected, fixed or repaired by the dept. I was involved with.
Maintenance Electrician
Sage Glass Faribault, MN
06/2018 - 03/2019
Install new projects in various places. Cad 5E installations to IDF cabinets. Troubleshoot machines. Keep the lines running and fix without a lot of downtime.
Journeyman Electrician
Mass Electric Waseca, Mn
11/2017 - 01/2018
Work on Waseca Solar project. Terminate wires and inverters. Cad 5 installation to inverters. etc.
Journeyman Electrician
Egan Electric Rochester, MN
11/2017 - 12/2017
Worked at Kasota Mn Solar project. Built the solar installation from the pile-ons to the finish.
Journeyman Electrician
NEO Electrical Services Hudson, WI
09/2017 - 10/2017
install under counter lighting on cabinets, run conduit and pull wire to power up switches for lighting and switch legs. install lighting and run conduit and wire to power up lights in communication room, and maintenance closets.
Journeyman Electrician
Ryan Electric Rochester, MN
06/2017 - 09/2017
Chatfield High School, Lincoln school, RPU power house off the 14.Install conduit, wire, fire alarms and communication systems. Install lights with low voltage switching and dimming capabilities.
Controls Technician
Fluor Rochester, MN
01/2016 - 04/2017
Assembled and installed wiring, electrical and electronic components. Calibrate Instruments on boilers, Chillers, Chilled water systems, Cooling tower water systems. Troubleshoot Device Net, Control Net, Scada, Metasys, PLC's - Control Logix, SLC 500, compact logix. Trouble shoot Air Handlers, VFD's, Motors and controls. Maintain and Trouble shoot compressors.
Electronics Technician
Crenlo Rochester, MN
08/2015 - 01/2016
Maintenance on CO2 Lasers and Fiber lasers, Welding Robots, hydraulic presses, bridge cranes, cable hoists, building facilities - water heaters, HVAC systems, space heaters, plumbing, carpentry, electrical. etc...
Assembled and installed wiring, electrical and electronic components.
Checked fluid levels and replaced filters.
Used hand tools to replace defective equipment parts.
Journeyman Electrician
IBEW Local 14 Eau Claire, WI
07/1999 - 08/2013
Electrical Installation on Commercial and Industrial jobs.
Instrument Technician
Various Contracors Long Beach, US
01/1993 - 07/1999
Instrument Technician, Electronics technician, Electro-mechanical technician, Controls Technician for Various Contractors in Refineries and heavy Industrial Companies in California, Texas, Louisiana.
Maintenance in refineries in southern and northern California, Texas, and Louisiana.
Offshore platform experience
Overseas experience
.
TRENT PASANO
”
Contact this candidate