Charleston Welding

**/**/****-**/**/****

Robert Thomas Iron Designs

Charleston,SC

Entry level job that taught me the basics to Blacksmithing. Carbon steel fabrication where we made cooking pans, skillets, and also a carbon steel Wok. Used hand tools, power grinder, hydraulic presses, hydraulic die cuts, attention to detail, measurements, hard work in a hot and humid environment, cleaneliness.

Capco Steel

11/15/2021-12/30/2021 (Temp.)

Providence,RI

Learned the basics to steel fabrication as well as flux core welding. Used various tools such as torch to cut steel, hand grinder, table saw, flux core welding and tig welding, read blueprints, troubleshooting, crane rigging as well as hard work and dedication to the trade.

Cash-Wa Distributor

08/26/2021-09/30/2021

Fargo,ND

Loaded semi trucks with pallets of food/food supplies in a timely and efficient manner, order picker which means I received a sheet/order and drove the pallet jack around to pick my orders, stack the products on the pallet in a uniform and precise manner so the load was even and no weight shift would occur. I relocated shortly after receiving this job for the steel fab apprentice course.

GPK Products

Fargo,ND

Drainage/sewer pipe bellinghead fabricator. My responsibilities for this job were to work 3 hydraulic bellinghead presses at the same time, read directions to fabricate 10” & 12” bellingheads for specific applications. Attention to detail was a must as anything as much of a quarter inch off could ruin a very expensive product, complete work orders, stack the product on the right pallets and send them to their correct location in the plant. Teamwork, fast paced environment, excellent communication, math skills.

Tamcoat Electric

2012-2013

Mooresville,NC

Residential electrical work, read blueprints, pull wire, basic hand tools and drills, retrofit older electrical panels, outlets, lights and wire.

Berg Electric

2011-2012

Commercial electrical work on UNC Hillsborough Hospital as well as a data center(Citrix). Pull wire, bend conduit pipe, label and wire up panels, read blueprints, work in a team environment, follow directions, pay attention to safety hazards.

As far as botanical and gardening/yard tending, I have enjoyed doing it since I was a young kid helping my grandparents and mom plant trees, shrubs, vegetables, trim trees etc. I thoroughly enjoy the work and fruits of the labor (pun might be intended lol) of working with nature and plants. I have been wanting to get into the cannabis industry for a long time I just haven’t had the opportunity.

Contact this candidate