Steve Pollind

Brea, CA ***** ● 1-714-***-**** ● adkh5w@r.postjobfree.com ● US Citizen

OBJECTIVE

Looking for a full-time engineering position where I can take my experience with either Power, HDL, or Hardware and contribute to a work environment

EDUCATION

Cal Poly Pomona 2017 – Present

• In Progress to Obtain a BS in Electrical Engineering

• GPA: 3.78

SKILLS

• C, C#, Assembly, Verilog

• MATLAB, Simulink

• Eagle, ltspice, OrCad,

• Oscilloscope, Spectrum Analyzer, Function

Generators, Basic Electronics Lab Equipment

RELEVANT COURSE WORK

• Introduction to Power

• VLSI

• Signals and System

• Control System

Engineering

• Digital Logic Design

• Circuit Analysis I, II

• Verilog

WORK EXPERIENCE

Western Digital Ramp Intern June 2020 – August 2020 Internship

• Worked from home to develop a GUI that improved the Margin Control of the Validation test that are performed on HDDs.

• GUI was required to have the ability to read and write to multiple Power Supplies and a Temperature Chamber at certain intervals.

PROJECTS

Automated Watering System May 2019 – July 2019

Personal Project

• Led a small group to pump water from a reservoir to irrigate plants in the attempts to reduced water waste

• Interfaced Light Dependent Resistor, Soil Sensor, and a water Pump with an Arduino to produce an algorithm that outputs the most efficient way to distribute water Small Unmanned Ground Vehicle (Electrical Team Member) September 2019-May 2020 Northrop Grumman Collaboration Project (NGCP-CPP)

• Worked through the preliminary and conceptual design phase to develop three different architectures. Performed trade studies based on a request for proposal to determine viability of both architectures and different electrical components.

• Developed a Printed Circuit Board that routed the power from regulators to components and housed a fuel regulator to determine battery health

Small Unmanned Ground Vehicle (Electrical Lead) May 2020-Present Northrop Grumman Collaboration Project (NGCP-CPP)

• leading a small team to develop the electrical system for an unmanned vehicle based off the specification from a request for proposal

• Currently working with a team to derive requirements from a request for proposal, trade studies on different proposed architectures, and begin development of vehicles power system.

Contact this candidate