A Team Upward Mobility

Angel Soliz

*** **** ****** *****

Texas City, TX 77590

832-***-****

**************@*****.***

Objective

To join with an organization that has an established record of putting safety first and mandates quality craftsmanship. It is my desire to work with a team that can utilize my skills and abilities to their fullest while allowing for growth and upward mobility.

Skills & Abilities

• CRAFTSMANSHIP

• GOOD WORK ETHIC

• EFFECTIVE COMMUNICATOR

• FAST LEARNER

• CURRENT TWIC, 70E TRAINING, BASIC PLUS SAFETY TRAINING, CPR

• TEST EQUIPMENT

Fluke Multimeters and Process Calibrators, Emerson 475, Crystal Gauges, Temperature Calibrators, Honeywell and Yokogawa Communicators, Level rigs and Current Drivers Experience

ELECTRICIAN

CONTRACT/TURNAROUND SERVICES AT VARIOUS FACILITIES 2/18 - 5/24 NCW, Amber, S&B, ISC, Bay Ltd., Brown & Root, Contech and Zachary

· Commercial buildings—install conduit for lights on road units and install power

· Pull cables to MCCs, install conduit and terminate junction boxes and marshalling cabinets

· Run conduit and install new wire systems in construction sites

· Run conduit from j-boxes to instruments

· Utilize P&IDs to verify instrument locations

· Terminate instruments

· Install lights and horns for unit

· DEMO burn out conduit cables and instruments in an alky unit

· Troubleshooting using blueprints, schematics, loops and other drawings Page 2

ELECTRICAL TECHNICIAN

YOKOGAWA 03/17 – 01/18

· Walkdown instruments in unit with P&IDs to verify model and serial numbers

· Calibrate instruments in the field and put in service using 475 communicator (Foundation Fieldbus)

· Install heat trace for analyzers throughout the unit and terminate to ax1 controllers

· Maintain analyzers troubleshooting all electrical and instrumentation problems INSTRUMENT TECHNICIAN ASSISTANT

INSTRUMENTATION AND ELECTRICIAL SPECIALIST 08/15 – 02/17

· Assist with cutover of instrumentation from Foxboro DCS and MODICON PLC to DELTAV and TRICONEX

· Install and loop check new instruments (pressure, level, flow and temperature)

· 5-point calibration of above instrumentation

· Pressure test tubing and fill legs per specs

· Communicate with board operator and outside operations to complete loop check

· Complete client documentation after commissioning I&E MAINTENANCE

INSTRUMENTATION AND ELECTRICIAL SPECIALIST 02/15 – 07/15

· Perform PMs on electrical motors (clean filters/verify AMP readings) and instrumentation (test alarms, PTPs, periodic calibrations and installation of replacement instruments if failure)

· Repair lighting circuits, run conduit, pull and terminate wire, clean oxidizer

· General cleanup of unit and storage areas

INSTRUMENT FITTER/ELECTRICAL HELPER

INSTRUMENTATION AND ELECTRICIAL SPECIALIST 06/14 – 02/15

· Bend, thread and run conduit, pull and terminate cables for MOVs,

· Bend and install tubing for control valves and instruments

· Install supports, braces and tray for conduit and instrument tubing PIPEFITTER/HELPER MAINTENANCE

CB&I 06/12 – 06/14

· Cutting, grinding and fitting pipe

· Cutting, grinding and placing plate steel for tank reconstruction

· Fire Watch/Hole Watch

· Assist welders

References

Available upon request

Contact this candidate