Eric C Benzler
West Covina, CA ***** 626-***-****
ad13f3@r.postjobfree.com
Electronics Test Technician
Electronics Test / Rework Technician. Experience in troubleshooting and upgrading, using test equipment to evaluate problem and repair to the component level. Experience with power supplies, inverters, micro-controllers. Various test equipment such as volt meters, oscilloscopes, thermal gun, microscopes for Surface Mount components and custom-built testers.
Wavestream, San Dimas August/2022 – April/2023
RF Test Technician
Testing with custom build test fixtures, testing block upconverters (BUCs) and IF boards for gain, tuning for flatness, measuring Phase Noise (PN), Phase Error (PE), and checking for SPURS and recording images from the Spectrum Analyzer, Network Analyzer and the Signal Analyzer for each unit tested. Mark units that failed and return for rework. Test re clocker for signal input and voltages, pass or no pass. Set up burn in for specific units for 12 hours and after burn in test and tune. Set up BUC unit for firmware download, pass or no pass if unable to load firmware, calibrate BUC using a GUI interface for gain, bias and flatness. Measure voltages on test pads, pass or no pass.
Intellipower, Orange, CA June/2019 – April/2020
Electronics Test Technician
Testing with custom build test fixtures, the PFC, DC-DC Converters and Micro boards for UPS systems. Using test equipment for testing, DC/AC Loads, volt meters and Oscilloscopes.
Increased the number of units tested using test fixtures and modified cables for voltage check. Setting up Excel spread sheet to track units in progress, units passed, and troubleshooting status.
Spectra Sensor, Rancho Cucamonga, CA November/2018 – December/2018
Electronics Test Technician
Set up laser for calibrated gas detector, calibrate for different gasses. Using Labview for testing.
Cameron, City of Industry, CA July/2018 – September/2018
Electronics Test Technician
Set up Wheatstone bridge with decade box and test, replace box with compatible resistors, and perform burn in test, and remove and test.
Macys, City of Industry, CA January/2012 – September/2017
Bench Technician
Troubleshoot and repair POS equipment used in the stores, including the printers, computers, scanners, monitors, hard drives and memory and also build the operating systems on both the POS register and Personal Computers, Supporting Windows 7 and Windows 10, with Windows 8.1 on the POS register. Reworked printed boards, soldering components such as capacitors, resistors and surface mount components. Using software to test and troubleshoot.
Power Wave, Santa Ana, CA November/2010 – December/2010
Electronics Test Technician
Set up four RF Amplifiers in cage with four power supplies, test each RF Amplifier using a Spectrum Analyzer.
Education
AS Degree (AS), Computer Science/Electronics
Citrus College, Glendora