Engineering Electrical

Rajas Moghe

Detroit, MI ***** 313-***-**** *****.*****@*******.***

https://www.linkedin.com/in/rajasmoghe

Objective

To secure an entry level position in Electrical and Computer Engineering field to enhance my skills of computing and embedded system programing.

Educational Qualifications

Wayne State University, Detroit, MI (May 2017)

Master of Science in Electrical Engineering

Relevant Coursework: Embedded Systems, Embedded Systems Lab, MATLAB simulation for Robotics, Digital Communication, Telematics, Parallel Computing, FPGA design, VLSI Design Lab, Sensor Fabrication Lab. Yeshwantrao Chavan College of Engineering, Nagpur, Maharashtra, India (May 2014) Bachelor of Engineering in Electronics Engineering Relevant Coursework: Embedded Systems, Embedded Systems Lab, MATLAB Simulation Lab, ORCAD Electronics Design Automation Lab, OOP, OS Organization, Linux OS, Soft Computing, Digital Circuits, Digital Communication. Technical and Computing Skills

Design: ORCAD and AutoCAD modelling, MATLAB, VHDL, Cadence modelling

Coding: C, Python, Linux, SCADA and PLC Programming, Micro Controller Programming, MATALB

Protocol: CAN, 3GPP

Academic Projects

Automated Active Safety System, Embedded System Design (May 2016)

Designed and built a working prototype to demonstrate CAN based autonomous accident avoidance vehicle on highway by lane changing technique using ultrasonic sensors and ATmega32 microcontroller.

Developed a 3-node CAN based system using embedded C coding to avoid accidental and emergency situations. 3-node CAN bus was simulated using the Vector CANoe software.

The advanced control systems can simulate the human driver completely and direct the vehicle based on interpreted sensory information to identify appropriate navigation paths using CAN protocol to avoid the obstacles. Two Link Robotic Arm, Introduction To Robotic Systems (December 2015)

Built a two-link robotic arm controlled by mini servo motors to maneuver in the space.

Using the Arduino UNO microcontroller linked with MATLAB software and the robotic toolkit, programmed the robotic arm to perform the task of following the path as per the project requirements.

Autonomous Traffic Control System, Engineering major project (May 2014)

Implemented the concept of autonomous traffic system along with three student peers with the help of a modified RC car using Arduino UNO board and Xbee module with a PC as the server.

Practiced troubleshooting techniques for interfacing of various modules and team coordination to develop a successful model system.

Programming for the Arduino board was accomplished using embedded C.

Documented results as thesis for final degree and presented findings for a class of 60 peers and five member jury panel using MS Power Point.

Distance Measurement Using Ultrasonic Sensor, Electronics Workshop Lab (December 2012)

Designed and fabricated a PCB for circuit with 40kHz ultrasonic Tx-Rx pair using ORCAD designing software.

Implemented with AT89C2051 microcontroller which was programed using embedded C on KEIL and RIDE as compiler.

Industrial Training

Prolific Systems and Technologies Pvt. Ltd., Nagpur, Maharashtra, India (June-August 2013)

Obtained hands on experience in industrial automation.

Topics such as PLC (general, Allen Bradley, Siemens), SCADA (Wonderware), HMI (Siemens), DCS (ABB) and Basic Electrical were covered as a part of internship course.

Contact this candidate