Professional Experience Engineer

Jon Jiang

***************@*****.*** 616-***-****

Professional Summary: Currently looking for a productive career as a mechanical, design, quality or product engineer. Gained four years of professional engineering experience and seek to apply them to the next job. Education:

UCLA

B.S. degree in Mechanical Aerospace Engineering minor in Electrical Engineering. Graduated in 2010 Cal Poly Pomona

M.S. degree in Mechanical Engineering minor in Manufacturing engineering. GPA: 3.65 Personal Information: 1. United State citizen. 2. Willing to relocate and travel. 3. Fluent in Mandarin Chinese Skill sets:

1. Proficient using ABAQUS/CAE. (3 years of professional experience) 2. Proficient at quality inspection. (1 years of professional experience) 3. Proficient using CATIA V5, SOLIDWORKS (2 years of professional experience) 4. Proficient using PROE/CREO (3 years of professional experience) 5. Proficient at using quality check tools (2 years of professional experience) 6. Proficient using TEAM CENTER PLM (2 years of professional experience) 7. Proficient at GD&T and Stack Ups (2 years of professional experience) 8. Proficient at Lean Manufacturing (2 years of professional experience) Certification and Training

1. PROE/CREO2: “Part Design”, “Advanced Assembly”. 2. CATIA V5: “Part Design”, “Surfacing”.

2. ABAQUS: “Introduction to ABAQUS CAE”, “Meshing”, “Contact and Convergences”, “FE-SAFE”. 3. LEAN Manufacturing: “Tim Childs Associate; Introduction to Lean Manufacturing” 4. GD&T: “Dimensional Management Systems – Introduction to GD&T” 5. Tolerance and Stack Up: “Dimensional Management Systems – Tolerance Stacks Using GD&T” Professional Experiences:

1. Mascon Inc. 04/01/2017 Present / Contractor Quality Engineer:

• Quality engineering: Quality checks, cost analysis, working with vendors in China and Taiwan to ensure quality standard. Perform dimensional measurement using calipers, micrometers and pin gauge. Help QC system implantation. Perform quality problem study.

• Improvement function: Manufacturing process improvement and cost down improvement. 2. Spartan Tools LLC 03/11/2016 1/12/2017 / Mechanical Engineer:

• Product design and analysis engineer for hydro jets devices which use high pressure water to clean sewer pipes. The challenge is to integrate all the components such as engines, pumps, water tanks, control systems and allow them to work properly. Design and develop hydro jets using PROE/CREO, AUTO DESK INVENTOR. ABAQUS/CAE. MATLAB simulation. Learned Lean manufacturing and Six Sigma; applied GD&T for precision machine design such as the wheel assembly and pump assembly,

• Applied Lean manufacturing to transform the production line; Implementing 5S and Kazan. 3. Dana Holding Corporation 06/23/2014 03/11/2016 / Product Engineer:

• Machine Design, Stress Analysis, Axle Systems, Commercial Vehicle Drive Line Technology. Design and analyze front steering axle, drive axle, drive shaft using PROE/CREO, CATIA V5. Use ABAQUS for FEA, then apply FE-SAFE for fatigue analysis. Applying Geometric Dimension and Tolerance.

• Gear engineering using CAGE, ABAQUS, CATIA V5. Applying Geometric Dimension and Tolerance.

• Product engineering, QFD, DVP&R, Design Reviewing, DFMEA, Testing and Application Engineering. 4. Southern California Edison 06/10/2013 9/27/2013 / Electrical Engineer Intern:

• Three month of experience as a summer intern at Southern California Edison. Perform substation design and analysis support to senior and lead engineers using AutoCAD; Gained knowledge of Substation design.

Contact this candidate