Quality Technician Supervisor

EDUCATION

Macomb Community College

Advance Processes/Automotive

*/**** - *******

Wayne Community College

Business Management

*/**** – 6/2001

Sawyer School of Business

Business Administration

8/1998 – 7/1999

Graduate

AWARDS

Scholarship, Macomb Community College

2015

LEARNING EXPERIENCE

2016-ISO/TS (Certificates)

FCA-2016 Supplier Training Week (Certificate)

FCA-2016 Layered Process Audit (Certificate)

FCA-2016 Basic Problem Solving Tools (Certificate)

FCA-2016 Quality Forever Requirements (Certificate)

FCA-2016 8 Stage Incoming Material Control (Certificate)

FCA-2016 3 Legged 5 Why (Certificate)

EXPERIENCE

ERAE Automotive, Pontiac, MI.

Quality Technician

2015 - Present

Produced Quality Alerts when needed, Inspection and certification of products before shipping to customer or being stored in warehouse, Responsible for creating and maintaining the Gage Calibration Log (i.e., Job Number, Serial Number, Model Number, Date of Calibration, and Next Due Date). Help support the pre-launch through the launch of products. Assist with Gage R&R and capability Studies for PPAP when required, Provide PPAP analysis information to appropriate entities via daily meetings, Responsible for assuring all required PPAP documents are loaded in the correct plant PPAP folders including lab documents (i.e., Drawing of Components with Revision Levels, Receiving inspection/Gaging Test Reports, Gage Calibration Logs). Provide/Record LPA analysis information to appropriate entities via daily meetings and online systems, Trained operators on conducting LPA’S, Liaison between Employment Agency’s regarding employees hourly reports along with sending their hourly reports via email on weekly basis to appropriate entities. Gaging and testing of incoming receiving components using calipers, micrometers, height gages, spline/plug gages, digital spline gages, Sent out gages for calibration, Assist with Rate of Run.

Yarema Die & Engineering, Troy, MI.

Quality Technician

2010 - 2015

As a Quality Control Technician, my job was to ensure that the manufacturing process was running effectively and safely while at the same time see that the operators followed the guidelines they were taught by keeping a sharp eye on materials so that unsafe products did not reach the customer. To accomplish this goal, I used height gages, check fixtures, calipers and micrometers and also conducted Layered Process Audits, assuring key work steps were being followed. I also took measurements and keep the records of incoming steel.

Forge Staffing/American Axle, Detroit, MI.

Machine Operator/Quality

2004 - 2010

I was a Press operator my responsibilities was to ensure good, quality parts were produced, packaged, and labeled correctly. As Quality control I was responsible for inspecting components from front and rear axles and drive shafts. It was a great company to work for.

Contact this candidate