Electrical Engineer Engineering

Seongmin (Shane) Jeong

**** *** ***** ****** *******, TX 77019

Phone: 281-***-****

Email: *******@*****.***

Objective

Seeking an Entry level position in Control and Instrumentation Technology Industry. Highlights

Self-motivated recent graduate with sound technical, communication, and leadership skills. Participation in various school projects with industry internship experience.

Education

B.S. in Engineering Technology

Control and Instrumentation Engineering Technology University of Houston Downtown, graduation date: July 30th 2015 Skills

• NI LabVIEW, Emerson’s Delta V, Aspen PLUS, SKM Power Tool, Siemens PLC, and P&ID, Instrumentation, Automation, PID control, PAS Tune Wizard, AutoCAD, and HMI.

• Bilingual: Korean

Projects

• Implemented PID control algorithm using PLC S7-300 and tuned the PID controller with Ziegler-Nichols’ second method, and then further improved the loop performance by trial-and error to finalize PID parameter settings.

• Practiced Modbus communication between Siemens PLC and NI LabVIEW.

• Optimized and analyzed chemical plant performance by Aspen PLUS.

• Operated Distributed Control Systems with Delta V to control signals from an array of analog transmitters (sensors) in the distillation column process. Fine-tuned PID controllers to optimize system performance.

• Demonstrated cascade control system based on analytical and empirical modeling and compared the tuning parameters between PAS Tune Wizard and hand calculation.

• Implemented a PC based speed control for low power DC motor, utilized I/O module which interfaced between the hardware and a PC, and a LabVIEW application program that handled I/O signal acquisition and interfacing, PWM signal generation, signal analysis, control algorithm execution, and HMI.

• Analyzed the static and dynamic properties of the measurement system and validated the Arduino Uno as a feasible DAQ for the temperature measurement application and thermocouple. Experience

Summer Intern (May to September 2013) - American Bureau of Shipping, Houston TX

• Researched effects on performance ratings for equipment operating in high ambient temperatures, participated in developing requirements, prepared a technical presentation and a report.

• Studied and researched technical standards (IEC, IACS, ISO, IMO, and CFR) related to projects.

• Designed one-line diagrams and calculated short-circuit current using power system design software, SKM Power tool. Summer Intern (May to June 2015) – Electronic Power Design, Houston TX

• Inspected all operating parts to verify they were within expected tolerances for proper operation after installation.

• Tuned and troubleshot control equipment for proper operation.

• Assembled machinery and electronic parts in accordance with customer schematics. Association Membership

The International Society of Automation

Institute of Electrical and Electronic Engineer

References

References available upon request

Contact this candidate