Engineer Network

OBJECTIVE

Seeking a Full-time position in Networking Domain. With the major focus on areas such as Network Engineer, Network Support Engineer, Network Operation Center (NOC), Datacenter and Virtualization. EDUCATION

Rochester Institute of Technology, Rochester, NY - Telecommunications Engineering Technology, MS Expected May 2016

Courses: Principles of Telecom Networks, Wireless Infrastructure & Policy, Fiber Optic Telecom Technology, Fiber Optic Telecom Technology Lab, Network Planning and Design, Wireless Communication Techniques, Telecommunication Concepts, Telecom Policy & Issues, Advanced Wired Networking Concepts. Mumbai University, Mumbai India - Electronics and Telecommunication, B.E. (Bachelors of Engineering) June 2012

TECHNICAL SKILLS

• Programming Languages: C, C++.

• Simulation Software: MATLAB, Multisim, Keil-C, Express PCB, HFSS, Quartus 2

• MS Word, MS Excel, MS PowerPoint, Windows, Macintosh,

• TCP/IP, DHCP, Multicast, RIP, OSPF, EIGRP, BGP Fundamentals, Redistribution, Policy Based Routing, Authentication, AAA, Frame Relay, STP, RSTP, MSTP, 802.1Q, VLAN, VTP, VACL, Private VLAN, Ether channel, HSRP, VRRP, GLBP, Switching, Class map and Access control lists, NAT/PAT, IPv6 Fundamentals, Quality of Service

(QoS), Wireshark and Virtualization.

• Fiber Optics, FPGA, Fusion splicing, OTDR, Photo diode. TRAININGS COMPLETED

• Cisco Certified Network Associate CCNA- Routing and Switching.

• Cisco Certified Network Professional CCNP- ROUTE.

• Cisco Certified Network Professional CCNP- SWITCH (IN PROGRESS). GRADUATE CLASS/LAB PROJECTS (Rochester Institute of Technology)

• Modeled the optical power & phase performance of a direct modulation using laser diode. (FALL 2014)

• Replaced the ED-COM JDS Uniphase EPM 605 photo diode to improve efficiency and (FALL 2014) design of photo receiver.

• Generated PRBS signal using Altera DE2 FPGA CYCLONE II educational board. (SPRING 2015)

• Network simulation and Analysis using GNS3 and WIRESHARKE In a lab environment every router was dual stacked with IPv4 and IPv6 addressing. I used EIGRP routing protocol and at each interface of the router, I implemented manual summarization. To connect remote offices i used FR cloud. And finally I did route manipulation and applied policy based routing to improve the quality of service. And then analyzed end-to-end connectivity. (SPRING 2015)

UNDER GRADUATE CLASS/LAB PROJECTS (University of Mumbai)

• Designed DC Voltage Regulators using IC 7805, step down transformer, diode & capacitors.

• Driving of step up motors using micro controller 8059 and using motor driver IC L293D to mobilize robots.

• Micro Strip Antenna Array- Designing and testing of 2.4 GHz micro-strip antenna array 1 X 4 patch for satellite and mobile communication on High Frequency Structural Simulator Software and implementation of hardware on printed circuit board.

EXTRACURRICULAR ACTIVITIES & ACHIEVEMENTS

• Have been one of the active members in the event management team of the technical symposium “NOVATEUR” of our college.

• Represented college in the basketball sports summit at MIT PUNE. Played football for three years in the intra college competition.

• Attended NCC camps for trekking, riffle shooting, paragliding, rock climbing also awarded NCC-A certificate. Yashvir Tomar 314 Crittenden Way Apartments, #4, Rochester NY-14623 **************@*****.***; *******@***.***;585-***-****

Contact this candidate