Engineer Electrical Engineering

Andrew Myrick

Associate Applied R&D Engineer

Melvindale, MI

********@***.*** - 313-***-****

WORK EXPERIENCE

Associate Applied R&D Engineer

Bourns Automotive - Auburn Hills, MI - July 2012 to January 2014

Simulated magnetic circuits using ANSYS Maxwell, and electronic circuits using NI Multisim. Wrote LabVIEW

code and macro scripts. Researched new sensing technologies. Developed and tested prototypes using 3D

printed parts and fixtures.

• Investigated suppliers and purchased new equipment, materials and software.

• Non-contacting sensor research, including:

Chassis level, steering angle, torque angle, fluid level, and transmission position sensors.

Help Desk/Consultant

Internet Walkabout - New Era, MI - January 2000 to October 2004

Answered technical calls repaired PC hardware for an internet service provider.

• Organized a door-to-door sales drive for the advertising department.

EXTRACURRICULAR ACTIVITIES:

• American Indian Science and Engineering Society east coast regional student representative, MSU chapter

president.

• MSU Audio Enthusiasts and Engineers, tube amp team.

• Volunteering at science museum teaching children about electronics.

EDUCATION

Bachelor's of Science in Electrical Engineering

Michigan State University - East Lansing, MI

May 2012

Electrical Engineering

University of Michigan - Ann Arbor, MI

2006 to 2008

Associates of Science in Electrical Engineering

Muskegon Community College - Muskegon, MI

July 2006

SKILLS

Wafer fabrication techniques, microwave antenna design and simulation, radar circuitry and software

development, analog circuit design, analysis, construction and testing. MEMS design. Proficient with ANSYS

Maxwell, SolidEdge, MATlab, NI Multisim and LabVIEW, SPICE, Cadence, Coventorware, Pinnacle Studio,

MS Office, Macro automation scripting, C, Mathtype, LaTeX. Lean manufacturing and Kaizen manufacturing

experience. Working DFMEA and FMEA knowledge. Basic CAN bus concepts and signaling experience, along

with some µ-controller CAN coding.

Contact this candidate