Electrical Engineer Engineering

Anicet Ndjiya

**** *** ********* *** #****, Takoma Park, MD 20912.

******.******@*****.*** 240-***-****

(U.S. Citizen)

EDUCATION

University of Maryland College Park, MD

Master of Engineering, System engineering, GPA: 3.6 /4.0 December, 2014

Bachelor of Science, Electrical Engineering, GPA: 3.2/4.0 May, 2012

COMPUTER SKILLS

Languages: C, HTML, J avaScript, Matlab, visual basic, C++.

Software: Matlab, ProEngineer, Microsoft Office, P spice, SolidWorks, scillab, LabVIEW, MicroStation, AutoCad.

TECHNICAL EXPERIENCE

University of Maryland College Park, MD

March, 2012 – May, 2012

Team leader: Inverted P endulum Stabilization design

Mechanically set up and electrically wired the motors and sensors for the project.

Imple mented a Matlab (Simulink) program that will stabilize the inverted pendulum.

University of Maryland College Park, MD

November, 2011 – December, 2011

Team leader: Obstacle avoidance robot that can solve a Maze

Designed and built an Obstacle detection and avoidance robot with Ultrasonic Sensors.

Interfaced battery, motors and Ultrasonic sensor to the Arduino Uno microcontroller.

Wrote the embedded C program used to P rogram the microcontroller.

University of Maryland College Park, MD

February, 2011 – March, 2011

Radio frequency trans mitter and receiver

Designed and simulated the circuit of radio frequency receiver and the matching transmitter using Pspice

Successfully built the circuit on a breadboard.

WORK EXPERIENCES

Hardesty & Hanover Engineering Annapolis, Maryland

October 2012 – Present

Electrical Engineer

Inspected the electro-mechanical and control systems of movable bridges in Maryland, Delaware and prepared reports

to describe findings.

Performed field inspection for information-gathering, troubleshooting, completion inspections and representation of the

owner in preparing review documents.

Provided emergency engineering troubleshooting services on the power, electrical and control system of heavy movable

structure, building and ventilation system.

Collaborated with engineers for the design of the power, electrical, electro-mechanical and control system of

ventilation system, buildings and heavy movable structure.

Reviewed and responded to contractors submitted shop drawings, catalog cuts, samples, specifications, and requests for

information.

Developed a MatLAB computer program to perform strain gagging computation, reducing the probability of making

mistakes and the calculation time from hours to seconds.

Performed voltage drop calculations on submarine cables and provided recommendation to MDTA.

Performed lighting calculations for the installation of light on the bay bridge ferry slip.

Calculated the cost to install different lights on the bay bridge ferry slip and advised about the best option.

Lead and managed the project for the installation of lights on the bay bridge ferry slip.

Genesic Semiconductor Dulles, Virginia

J uly 2012 – August 2012

Power Electronic test Engineer

Designed PCB board using Eagle PCB software and tested man y electronic assemblies.

Collaborated with engineers for the design of equipment for high voltage measurement and testing up to 20000Volt.

Developed program in C++ to interface Mbed microcontrollers and control circuit.

RELEVANT SKILLS

Foreign languages skills: French: Fluent

Contact this candidate