Project Engineer

Hamisi Kussaga

**** ***** ***** **. ***** Bend, Indiana 46614 574-***-**** ********@***.***

*.*******@*****.***

HIGHLIGHTS OF QUALIFICATIONS.

Electrical and computer engineering student experienced in Programming Language and Operating systems: C/++C, MATLAB, PLC, Visual Basic and Python.

Using screwdrivers, wrenches, socket wrenches, pliers, hammers, chisels and punches to troubleshoot and repair equipment problems.

Detail-oriented, efficient and organized professional with extensive experience in building, and troubleshooting circuits.

Excellent written and oral communication skills, Project management, engineering change request,

Building circuits and testing.

Proficiency in reading, comprehend schematics and the ability to use an oscilloscope, a spectrum analyzer and a soldering iron.

Repairing or replacing defective equipment parts.

Cleaning and observing some bad traces.

Education & Certifications

Bachelor of Science Electrical and Computer Engineering Technology Candidate May 8, 2017

Purdue University, Indiana

Associate Degree in Applied Science in Electronics Technology May 18, 2015

Ivy Tech State College, Indiana

Skills & Course Summary

Computer Programming

PLC Programming

Circuit Analysis

AC/DC Circuit Troubleshooting

Computer Graphics Technology

AutoCAD

MultiSim

MatLab

Visual Basic

MS Office

MS Visual Studio

InDesign

Linux

Data Design & Management

Python Programming

Power Factory

PLECS

Academic Project Experience while in college

thermo device 01/2016-05/2015

The project scope was focused on internet.

The goal of this project was to record temperature changes in a device while you’re inside.

.

NXT logic elevator 08/2014-12/2016

The project scope was focused on sensors, detection algorithm and wireless sensor data transmission.

The goal of this project was to write a code and upload into an elevator micro processor and it’s going to move elevator up and down according to the code designed.

SMART BLIND BELT

01/2017-05/2017

The project scope was focused on sensors detection of an obstacles around.

The goal of this project was to help blind and visual impaired to navigate without using any assistance guide.

Employment Experience

KIK CUSTOM PRODUCTS

Recording data from different equipment such as TTV, Gas calibrator, Machine Pump calibrator, counting bottles speed in the conveyor belt to determine accuracy speed and adjusting belt whenever is needed.

Using the data collected to determine the performance (efficiency) of the machines and writing a report for the future references.

Recording performance of lines, finding target line, and if is down we determine performance of each line and its target.

Reporting any leakages on some machines for maintenances and reporting it to the engineer team.

HY TECH AUTOMATION REPAIR

Troubleshooting various power supplies, servo amps, circuit boards and servo drives.

Soldering, de-solder and replacing components at board level.

Testing and repairing industrial electronics such as contactors, switches and relays.

Learned to mark EVERY wire and either make some drawings of everything disassemble parts.

Cleaning, testing and charging capacitors, and replacing bad ones.

Maintenance and repair of AC and DC drives, PLC's, servos and process control systems.

Proficient in reading wiring diagrams, electrical schematics and good in understanding of ladder logic.

Troubleshooting and repair of sensors, starters, relays, timers, push-buttons, switches and wiring.

Troubleshoot and repair constant potential AC and DC motor controllers.

Troubleshoot and repair DC and AC variable frequency drives.

I have the knowledge of process control instrumentation and installation of conduit and wiring as well.

Contact this candidate