Engineer Design
Resume:
LAM S. NGUYEN
**************@*****.***
OBJECTIVE: Seeking for an Engineer position.
EDUCATION: B.S Degree in Electrical Engineering (2007)
(3 years System Engineering training program at KLA-Tencor)
EXPERIENCES:
Mar.15 – Present Manufacturing Design Engineer III KLA-Tencor, Milpitas CA
Design and develop manufacturing processes for new products and enhancements, and related tooling and fixtures which are consistent with a zero defect level as well as low product cost
Identify and implement cost improvement programs across all product lines, at contract manufacturers and in house production.
Responsible for identifying issues in manufacturing and resolving them per the quality system requirements
Ensure changes to processes have thorough justification and where applicable, validated to meet the regulations and the Company’s quality system
Ensure the test protocols and reports are thorough, provide all required details to reproduce the study at a later date and ensure the data sheets for the studies are well designed to capture all required data
Develop protocols and perform product verification and validation testing
Perform process-related design tasks to support pilot manufacturing
Support system network, VMware technologies, Windows Servers, Red Hat Enterprise Linux (RHEL), and Unix SUSE servers
Support hardware and servers interface
July.06 – Mar.2015 Associate Test Engineer KLA-Tencor, Milpitas CA
Evaluates and analyzes data acquired during tests.
Makes recommendations for process or design modifications based on analysis
Performs failure analysis, uses data for product industrialization changes
Interface with software engineers to ensure successful software and hardware integration
Troubleshoots test equipment, test process, and product issues
Supports engineering R&D, manufacturing design test fixtures, and redline procedures
Feb.06 – July.2006 Electronics Technician Scintera Networks San Jose, CA
Setup tests, familiar with Signal Generators, Frequency Generators, Spectrum Analyzers, Oscilloscopes, Digital Multi-meters, and Error Detectors.
Test IC, and EPROM 10G prototype Chips.
Dec.98 - Jan. 2002 ElectroMechanical Tech. Temptronic Corp., San Diego, CA
Built thermal test fixtures.
Test, repair PCBs.
Assist Development Engineers to change protocols.
Jun.95 to Dec.98 ElectroMech/QA. Medication Delivery Devices, Inc., CA
Test, validate and QA inspection of Diffusion Medical Electronic Products.
Record of qualify issues, provide feedback and recommendation to product engineer for qualify improvement
Develop QA checklist
Other Trainings and Experiences: IC Layout, CMOS Design and Fabrication Process, Servers (Intel/Opteron/SPARC-based), OS (Linux, UNIX, Windows), VMware, Networking and Storage Systems.
Contact this candidate