Electrical Construction

Wayne E. Cotten

Wayne E. Cotten

***********@*****.*** Ft. Lauderdale, FL 347-***-****

Objectives

To secure a position with a progressive electrical company that will appreciate my desire to perform to the best of my ability and allow me to utilize the skills that I have acquired through school training and work experience.

Experience

RockTenn Delaware Water Gap, PA

Electrician 2012 – 2013

1. Read, interpreted and worked from blueprints, sketches, layouts, circuit diagrams or specification.

2. Troubleshoot, repair and adjust electrical controls systems.

3. Replaced broken or defective parts in equipment or machines and electrical equipment

4. Experience with industrial controls, conveyance systems, motor control centers, power distribution panels, electrical starters, variable frequency drives (VFDs).

5. Basic PLC construction/troubleshooting.

Alcan Packaging Washington, NJ

Electrician 2008-2010

1. Basic PLC construction/troubleshooting.

1. Troubleshoot, repair and adjust electrical controls systems.

2. Install and test electrical fixtures, control equipment, and wiring.

3. Read, interpret and work from blueprints, sketches, layouts, circuit diagrams or specification.

4. Maintain and repair wiring, motors, switchboards, switches and electrical mechanisms.

5. Inspect, maintain and repair various types of indoor and outdoor light fixtures.

6. Ispect, clean and lubricate AC/DC motors.

7. Setyp/tune variable frequency drives.

8. Understand AC & DC circuits, conductors and terminology.

9. Understand and apply the National Electrical Code (NEC).

10. Fit and conndect conduit using various tools necessary to layout, cut, thread and bend.

11. Experience with 24vdc and 120vac control circuits.

12. Experience with 208 and 480v/3 phase power.

Nestle Waters Breinigsville, PA

Production Operator 2007-2007

1. Operating and maximizing effeciency of high speed bottling or packaging equipment.

2. Equipment troubleshooting.

3. Preventative maintenance.

4. On line inspections and data recording

Trade Source, D/B/A P & W Electric, New Hyde Park, NY New Hyde Park, NY

Electrical Apprentice 2004-2005

1. Assisted in installing raceways and conduit.

2. Wired high based lighting.

3. Assisted in installing necessary wires to serve central air conditioning and heating units for commercial buildings.

Education

Triangle Tech

2006-2008 Associates degree in Maintenance Electricity and Construction Technology

Courses: *Residential Construction & Electrical Floor Plans *AC/DC Mortors and Generators *Residential and Commercial Services *Low Voltage, Motor Control Circuits *Lighting and Luminaries *Industrial Controls *Commercial Power Distribution *Raceway Systems *Industrial Distribution and Panel Board *Special Occupancies & Conditions *Single Phase Pwer Transformer *Overcurrent Protection *Three Phase Transformer Banking *Cost Estimating *Three Phase Motors and Installations *Development & Installation of PLC’s

Northampton Community College

2006

Courses: *National Electrical Code

L.A. Wilson Technology Center

2000

Courses: *Residential Wiring *Residential Services

Job Corps.

1996

Courses: *GED 1996 *Floor Covering

Pocono Mountain Senior H.S

1996

Awards & Achievements:

Dean’s List October 2006 and June 2006

Two Recognitions of High Honors October 2006 and June 2006

References

References are available on request.

Languages

Fluent in English/Spanish

Contact this candidate