Mechanical Inspector

Nhat Doan

**** * ****** ***, ** *****

408-***-**** or *************@*****.***

Objective: Obtain a position as a Mechanical Inspector

Education: Pursuing a B.S Degree in Computer Engineer (Senior Student)

San Jose State University, San Jose, CA

Certificate: Machinist (2011)

San Jose City College, San Jose, CA

Certificate: System technician (1998)

Polytech Institutes, Santa Clara, CA

Certificate: Computer Technician (1997)

Electrocomp Institutes, San Jose, CA

Graduate: Diploma (Honor) (1994)

Oak Grove High School, San Jose, CA

Experience: Highland Metals Inc, (8/1997 to 9/2012)

San Jose, CA 95125

• Experience in receiving, first article, in process, and final inspection.

• Experience Metrology, and Gauging System, Caliper, Micrometer, Feeler Gage, Pin Gage,

Ruler, Microscope, Depth, ID, OD Micrometer; Optical Comparator, Go,No Go…

• Blueprint reading, GD&T, ANSi Y 14.5, and corrective action.

• Experience with a lot of metals and plastics materials such as Copper, stainless steel, titanium,

alloy aluminum, Beta Blue…

• Set Up, Operate Manual (Torrington) Machine to form various Arch

Wires for Orthodontist and Inspect finish parts

• Set Up, Operate various machines such as; Drill, Braided,

Straight Length (Toshiba)

• Able to Repair, Maintenance, and replace machine parts

• Able to modify, design simple machine parts, and do experiment

To improve quality and production.

• Ensured that the measurements are accurate.

• Ensured quality of the production by making adjustment on controls and operating devices.

• Reported machine malfunctions to the supervisor.

• Adjusted machining parameters as needed to achieve highest throughput possible

• Ensured machined parts are within drawing specified tolerances, parts are cosmetically

acceptable and protected from damage

• Trained on (G&M,H,F,S…) codes programming, how to make simple program edits such as

feed and speed, material size, adjustments for shaft taper and etc.

• Managed tooling and tool wear offsets to maintain machined dimensions within tolerances.

• Proof out new programs and conduct 1st article inspection

• Select tooling required by program, set tools precisely and with maximum rigidity to achieve

best surface finish and dimensional repeatability.

IBM (10/95 to 7/97)

San Jose, CA 95123

• Set-Up & Operate 8 different kinds of Machines

• Work in clean room to test Actuator and work with engineers

to test new laser test machines

• Trainer

Experience: (Since1998)

• MS Word, Excel, Email, and most MS Applications

• C, C++ Language, Oscilloscopes, DVM and Signal Generators

•Testing of both Digital and Analog equipment

• Hands on build PC, install, and configuration,

• Able to troubleshoot most windows & application softwares

• Hands to setup Local Network, Hubs, Router …

• Able to share hard-drive, Remote Access and PC anywhere (LogMeIn)

• Able to Back Up, Restore Windows and Softwares (Norton Ghost)

Contact this candidate