David G. Whittle
Moreno Valley, CA 92557
****************@*****.***
Objective A challenging position in the electrical industry.
Professional 2010 - 2011 Baxter Electrical Contractors, Inc.
experience Corona, Ca
Electrician
I worked as a commercial electrical foreman. I worked on underground
piping for primaries and secondary to finish on restaurants, Retail
Building and Remodels. I am left in charge of certain tasks like
ordering material, layout, inside and outside lighting.
2005 - 2010 C n D Electric, Inc.
Riverside, Ca
2002 - 2004
Electrician
I worked as a commercial electrical apprentice. I worked on
underground piping for primaries and secondary to finish on
restaurants, Retail Building and Remodels. I am left in charge of
certain tasks like ordering material, layout, inside and outside
lighting.
2004 - 2005 M.L. Electric Works, Inc.
Riverside, Ca
Electrician
I worked as a commercial and industrial apprentice. Jobs included
churches, schools and warehouses.
2004 Windsor Heights Electric.
Riverside, Ca
Electrician
I worked as part of a team doing tenant improvements on both
commercial and industrial buildings. Jobs included office building,
banks and warehouses.
2000 - 2002 Sprint Electric Co.
Riverside, Ca
Electrician
I started out as a residential homerun puller learning the basics of
circuiting. I worked my way up to trim foreman where I was in charge
of ordering material, managing the job schedule and coordinating
necessary tasks with the job superintendent.
Education
1991 - 1992 I.T.T. Technical Institute San
Bernardino, Ca
Applied Physics
I studied applied physics for a little over a year with applications
in drafting. I learned computer aided drafting as well as board
drafting. I learned how to apply these skills in mechanical, civil
and architectural aspects. However I was unable to continue my
studies due to personal situations.
1994 Riverside Community Collage Riverside,
Ca
Law Enforcement
I received my P.O.S.T. (Police Officer Standards and Training)
certificate from Riverside Sheriffs department. I completed the
course with an 87%. I finished fourth in physical training and
fifteenth in academics. (out of 38 students.)
Skills
Reading blue prints.
Bending pipe.
Basic knowledge of circuiting.
Basic knowledge of motor control.
Good knowledge of residential and commercial code.
I can operate forklifts, trenchers and backhoes.