Mechanical Engineer

TAREK ABDALLAH

**** **** ***** *** . *******, FL 32824

PHONE 407-***-**** . E-MAIL **************@*******.***

OBJECTIVE

To further enrich and diversify my mechanical/manufacturing engineering

career, gain valuable experience, and make contributions that are valued

and recognized.

EDUCATION

[9/2000 - 6/2005] Central State University Wilberforce,

OH

Bachelor's of Science in Manufacturing Engineering

. Overall GPA: 3.5

EXPERIENCE

[5/2006 - Present] Lockheed Martin Orlando, FL

Manufacturing Engineer

. Work Experience: 5 years

. Supported day to day production operations by managing production

schedule deadlines, lead troubleshooting hardware efforts, and

ensuring hardware complies with all quality standards

. Implemented corrective actions and preventative measures to eliminate

costly manufacturing defects which reduced build time by 10% on

average

. Experienced with optical, electrical, and mechanical assemblies

o Optical: 2 years

o Electrical: 3 years

o Mechanical: 2 years

. Worked with cable/harness assemblies, circuit cards, telescoping lens

assemblies, and mechanical parts

. Created process plan work instructions for assemblers to follow to

migrate from first run manufacturing to full scale production

. Supported programs from inception to full scale production phase

. Reviewed and approved blueprints and implemented principles of Design

for Manufacture & Assembly (DFMA) where possible, leading to an

average of 20% reduction in build time

. Green belt certified in Lockheed Martin's internal Lean Six Sigma

course (kaizen, value stream mapping, PICK charts, fishbone diagrams,

etc)

. Wrote manuals for operating equipment to eliminate potential operating

losses and achieve start up goals

. Led VUIT-2 Antenna Producibility team to investigate ways to reduce

cost, assembly time, increase ease of assembly, and other continuous

improvements

o Reduced build time by 50%

o Team consisted of various members from different production

organizations

o Led effort to solicit input from engineering, program

management, and quality organizations

o Created a producibility training module to educate all new entry

level engineers in the principles of Design for Manufacturing

and Assembly (DFMA) and Continuous Improvement using actual

company examples

Contact this candidate