Electrical Machine Operator

Nicholas SanchezNicholas Sanchez Nicholas Sanchez

**** ***** **. ***. * Corpus Christi, TX 78412

Phone: 361-***-**** E Mail: Nsanchez86@yahoo.comNsanchez86@abhndt@r.postjobfree.com

Objective

My objective is to utilize my skills and knowledge to make a better, safer, and more productive work place for my co workers

and I.

Experience

Vanguard Resource Corporation 2009 Present

Install, modify, repair, troubleshoot, load and test new and existing electrical lines, circuits, complete systems, fixtures,

controls and equipment.

Install, maintain, and repair distribution panels, switchgear, power and control circuits, fire alarm and signal systems.

Plan and lay out the routing, placement, type, size, gauge, balance and load for continuity and proper and safe operation

of electrical lines, circuits, systems, equipment and controls such as load control centers, electrical and electronic

regulating and control devices from building plans, blueprints, wiring diagrams, engineering drawings and electrical

maintenance and repair manuals.

Interpret and apply National Electrical Code and local codes to work practices.

Project Specialists, duties would consist of ordering material, coordination with other trades, supervise small crew (4),

report and update Project Managers.

When projects were not available, I would resume all forms of electrical duties but not limited to running conduit,

pulling wire, installation of panels, transformers, fixtures, and devices. Termination and trim out, and trouble shoot

problems throughout the base. Also the uses of many tools, meters, and equipment.

Preventative maintenance was apart of out monthly duties; PM’s consist of checking panels, transformers, and motor

controls for proper voltage, amperage, and operation. Voltage ranges from 24vac to 480vac single phase and three phase.

High voltage Pm’s consisted of checking and monitoring MCC’s, and main sub stations voltage very from 600VAC and

higher.

All forms of electrical work but not limited to running RMC, EMT, Flex, MC Cable, Seal tight, Carflex, SO Cable. The

running and bending of conduit ranged from ” to 4” sizes, conduit was bent using hand benders, Chicago, and

Sidewinder.

KGS Electric Co. 2004 2009

Machine operator for all preliminary work, which consist of underground for primary and secondary power, and

communications. Area mechanic for all company vehicles.

Rough in for block, brick, sheetrock, wood, stud, and tilt walls, roughing in slab for concrete pours. Running conduit and

pulling wire. Installation of many forms and types of lighting fixtures. Trim out of panels, fixtures and devices.

Construction and organizing or electrical rooms. Installation of panels, transforms, main switchgear, main distribution

panels, motor controls, relays, contactors, time clocks, VFD’s. Troubleshooting throughout project, blue print,

schematic, and diagram reading. Voltages from 24vac to 480vac, single phase and three phase.

Page 2

Company mechanic for area vehicles. Duties were to tune up, repair, or transport vehicles. The following duties required

the use of many intercut tools, machines, and gauges. The use of OBDII to read and trouble shoots electrical problems,

and the link up of a laptop to properly tune gasoline engine.

Education

Sinton High School 2000 2004

04 Graduate, diploma received.

Craft Training Center 2005 2009

4 Year electrical apprenticeship program, graduated and certificate received.

Electrical Arc Flash Safety Training

4 hour class on voltages over 600VAC and safety preparations and precautions.

Skills

Certified in 50 States

Journeyman Electrician

High Voltage Certified

Security Clearance for Federal and Government Jobs

Machine Operator for: Areal Lift, Scissor Lift, Forklift Certified by Engineering Safety Consultants and Government

Contact this candidate