Engineer Data

OBJECTIVE

To achieve a respectable position where my knowledge can be shared and

enriched by strengthening my technical and analytical skills by

contributing my best.

EDUCATION

Graduate

Master's in Telecommunications.

GPA - 3.43

Southern Methodist University, Dallas, TX

Jan 2008 - Dec

2009

CERTIFICATION

. Cisco Certified Network Associate- CCNA (640-802), Cisco

Systems.CSCO11768243.

TECHINCAL SKILLS

. Wireless Technologies: 2G/3G Technologies.

. Networking: IP, SIP, RIP, IGRP, EIGRP, OSPF.

. Microsoft office suite.

. Operating systems: Windows - XP, Vista, Windows 7.

RELEVANT COURSEWORK

. Wireless Cellular and Personal Communications (Wireless Standards and

Evolution).

. Internet Protocols (IP), Internet Telephony, Wireless Internet .

. Advanced topics in Wireless Communications (2G/3G Technologies,

Network Architecture and elements)

WORK EXPERIENCE

Glow Networks, Dallas, Tx

May 2010 - Present

Worked for USCC, Verizon, T-Mobile- Associate RF Engineer

. Collect UE physical measurements for all the cells in the active set

using Wireless Logix XCAL data collection software.

. Verify Handover functionality performance, site functioning, antenna

positions and swapped feeders.

. Identify call related problems such as dropped calls, hardware

problems, verify call success rate and call drop rate.

. Processing and uploading the log files & drive test statistics to the

server on daily basis

. Assisted in optimizing the network performance by monitoring Dropped

calls, Blocked calls Handover failures, Throughput, Missing Neighbor

Detection

. Using XCAL and providing 3G RF related problems like Weak Pilot areas,

Neighbor addition and deletion, Pilot pollution, Huge Soft Handover

Overlap and Call Drops

. Testing coverage of the network by measuring the parameters like Tx

Power, UTRA carrier RSSI, Target SIR

. Monitoring network parameters such as SIR, SQI, RRC state, RSSI, BSSI,

uplink/downlink power levels.

. Processing and uploading the log files & driver statistics to the

server on daily basis

. Creating a report on number of cell sites covered, RF signal

parameters, handoff failure/success, dropped calls

. Equipment calibration and cluster drives for testing UMTS network

using XCAL.

. Verify CDMA/EVDO basic functionality, power related issues and

neighbors relations list.

Glow Networks, Dallas, Tx

May 2010 - Present

Worked for SPRINT, Associate RF Engineer

. Data processing drive test data using XCAP to provide the daily

report.

. E911 testing for the new cell sites.

. Prepared drive route maps for testing on MapInfo.

. Analyzing data and suggesting solutions for poor data rates, handoff

failures, power levels and poor signal strengths.

. Assisted in testing the Radio Network Controller (RNC) for Handover

control & Radio Channels.

. Performed Voice shakedowns for cut-night using XCAL.

Jr Network Engineer,

Dec 2009 - May 2010

Plexus Unified Communications.

. Set up the VOIP phones in small network's using CME and worked on WAN

connectivity using Routing and Switching Techniques.

Southern Methodist University, Dallas, Tx

. Worked as Technical Student Assistant for Information Processing at

Undergraduate Enrollment Division, SMU.

PROJECTS AND PRESENTATIONS

. Analysis of Data Frames using ETHEREAL Protocol Analyzer:

Using Ethereal Sniffer I have presented a report on analysis of Data

Frames in Internet Protocols where I observed the transmission of packets

from one location to another.

. Techniques to enhance data rates in GPRS/EDGE:

In this paper I could learn the modulation techniques like 8PSK, MIMO,

Spatial Multiplexing, OFDM and 64QAM to enhance data rates in GPRS/EDGE.

. Mobile Wimax:

Architecture and logical functionality of mobile Wimax is studied through

this paper.

REFERENCES: Available on Request

Contact this candidate