Electrical Design Engineer
Resume:
Hong Minh Nguyen
***** ******* *** ***********, **: 92683
E-mail: ****************@*****.***
EDUCATION:
CALIFORNIA STATE POLYTECHNIC UNIVERSITY POMONA BACHELOR OF SCIENCE ELECTRICAL & COMPUTER ENGINEERING
CONCENTRATION: POWER ELECTRICAL AND ELECTRONICS
EXPERIENCE:
SENIOR DESIGN ENGINEER August 2011 to Present
ARGA CONTROLS ELECTRO SWITCH CORP (Transducer, Battery Voltage Monitor, Power Frequency Regulator/Generation… Manufacture), Monrovia CA
Design and Develop measurement and control technology in large products for precision instrumentation in the areas of industry including power generation, utility, cogeneration, petro chemic, communication, aerospace, and multiple industrial plant applications. Virtually anywhere specialized instrumentation is required to measure, regulate and control power.
ELECTRICAL ENGINEER April 2008 to April 2009
T3MOTION (Electric Vehicle Manufacture), Costa Mesa CA
Design and develop chargers for Electric Vehicle, control motors, EMI circuit design. I was personally responsible for passing The T3 Motion’s Electric Vehicle EMC Certificate
ELECTRICAL ENGINEER December 2005 to November 2007
MARTEK POWER (Power Supply Manufacture), Torrance CA
Design EMI filters to comply with Regulator Agencies (FCC A, FCC B, EN55022A, EN55022B…).
Designed high frequency power XFRMs, Buck Boost, Magnetic Amp regulators, and output chokes. Design custom linear and switch mode power supply (AC-DC and DC-DC) from prototype to mass production. Complete power supply characterization to make sure designed power supplies comply with customer’s specifications. Knowledge of Control Theory (measure loop response via bode plot and step load). Familiarity with topologies: buck, boost, forward, fly -back, push pull, and half bridge. Knowledge of packaging concept (power flow; avoid air restriction to dissipated area). Familiarity with schematic captures and circuit analysis tool, Experience with oscilloscopes, spectrum analyzer, and loop measurement tools. Analyzing of thermal for reliable power supplies.
ELECTRICAL ENGINEER February 2005 to August 2005
CARMACO WIRLESS TECHNOLOGY CO (Micro-Power Electronics Manufacture), Irvine CA
Developed and tested Micro-Power Electronic Products such as Notebook, cell phone chargers
ELECTRONIC ENGINEERING TECHNICIAN June 2003 to December 2003
INTERNATIONAL RECTIFIER (Power Semi-Conductor Technology Manufacture), El Segundo CA
Perform Tested, and Evaluated Power Diodes, MOSFET’s, IGBT
ELECTRICAL ENGINEER March 2001 to February 2002
Power Test Solutions (Consultant Engineering Group), San Diego CA
Designed and developed automated manufacturing test for power Supply products
ELECTRICAL ENGINEER October 2000 to February 2001
Magnetek (Power Supply Manufacture), Chatsworth CA
Automated Test Design, Analog and Digital circuit design for power supply
POWER SYSTEM ENGINEER May 2000 to October 2000
Lightning Strikes CO. (Movie Product Company), Hollywood CA
Design and test power supply, Technical Support for lighting technique. Develop technique to control power electronic circuits. Using IGBT and SCR’s
ELECTRONICS TECHNICIAN January 1999 to April 2000
POWERWAVE TECHNOLOGIES (Power Amplifier RF Signal Manufacture) Irvine, CA
Laboratory test, define & troubleshooting Multiple Carrier Power Amplifier
POWER SYSTEM ENGINEER September 1997 to November 1998
LIEBERT CORPORATION COMPANY (U.P.S System Manufacture CO) Irvine, CA
Perform analog, digital circuit design, and analysis. Power electronics Circuit design and support for Static Bus Transfer Switch (SBTS), Uninterruptible Power Supplies by using SCR’s and IGBT technology. System, technical/ sustaining issues as required: Manufacturing, EMI, UL, Thermal, and Electrical Testing
PERSONAL: US citizen
Contact this candidate