|
Resume alert |
Resumes 31 - 35 of 35 |
Aiken, SC, 29803
... Specified, purchased and installed 1.5 million dollar heat treat furnace and CNC milling machine. Education Purdue University -Bachelor of Science, Agricultural and Biological Engineering Kettering University (formerly General Motors Institute) ...
- 2010 May 20
North Augusta, SC, 29841
... Implemented tool management and inventory system for CNC department, which resulted in $72,300 annual cost savings by reduction of unused inventory and recycling of materials. Invented pneumatic thread gaging system for support of one-piece flow ...
- 2010 Mar 09
North Augusta, SC, 29841
... My other duties were, Draw and Prototype new parts in Cad/Cam software, run and program (2) CNC Plasma’s, 1 Welding Robot, 1 CNC Pressbrake. I also ran Knee Mills, manual Lathe, Automatic Saws, ect..I made sure routine maintence was done on all ...
- 2010 Mar 09
Trenton, SC, 29847
... Supported and programmed for the CNC Machine Department, and led the 30 associated in the Machine Shop Department. Education Strom Thurmond High School School Curriculum Johnston, South Carolina Graduated May, 1987 University of South Carolina ...
- 2010 Mar 09
AUGUSTA, GA, 30906
... Augusta, GA CNC Operator Read blue prints, determined bevel size, and cut base plates for steel beams. Monitored machine performance and output for defects. Ensured optimum machine utilization. Maintained and analyzed required reports. ...
- 2009 Jun 23