Electrical Engineer Design

Thuan Mai

* ********* ****

Dover, NH *****

603-***-****

*********@*****.***

Summary

Electrical engineer with four years of laboratory experience designing and testing various electrical circuits. Documentation experience of the design process: FMEA, PDR, FDR, Cost Analyses, Reliability Analyses, Identifying Points of Failure and Design Verification Plans. Knowledge of digital signal processing, wired/wireless data communications, and control systems. Designed and tested a printed circuit board in Cadence. Utilized an H-bridge in the motor controls of a remotely operated vehicle. Tested and repaired temperature control units.

Skills

• Soldering

• Crimping

• Matlab

• Electrical test equipment

• PCB design • Microsoft Word

• Microsoft Excel

• Microsoft Powerpoint

• Java

• H-bridge motor controls • Multisim

• Cadence

• Circuit board wiring

• Troubleshooting electrical and mechanical components

Work Experience

Thermo Fisher Scientific 2011 – 2012

Test technician. Newington, NH

• Validate that temperature control units are assembled correctly

• Configure the circuit boards to ensure that temperature control units will operate

• Record voltage and amperage readings

• Verify high temperature cutoff

• Verify low temperature cutoff

• Calculate heat load and verify if the heat load is correct

• Calibrate and record temperature offset

• Measure pump dead head pressure

• Measure refrigeration pressures

• Restore factory defaults

• Troubleshoot any problems that occur

US Census Bureau 2010

Enumerator. Dover, NH and Rochester, NH

• Completed Census questionnaires with households which did not fill out their questionnaires already

• Visited houses in Dover and Rochester

• Planned routes according to maps of the surrounding area supplied by the Census

UNH ROV 2009-2010

Electrical Design. Durham, NH

• Documentation experience of the design process: FMEA, PDR, FDR, Cost Analyses, Reliability Analyses, Identifying Points of Failure and Design Verification Plans

• Assembled an underwater remotely operated vehicle (ROV)

• Researched and purchased all the necessary components to assemble the vehicle

• Utilized four H-bridges to control four motors within the vehicle

• Worked with mechanical engineers in order to build the ROV

Education

University of New Hampshire

Bachelor’s Degree in Electrical Engineering

Contact this candidate