Resume

Phillip R. Rozell

**** *. **** *******

Kansas City, KS. 66109

913-***-****

*************@*********.***

QUALIFICATIONS:

I have a lot of knowledge and experience repairing single and 3 phase electric motors, controls, and all type of power tools: electric, cordless and air tools. I took winding data and made coils and used test panels to test run motors and all other shop equipment. Repaired pump units and condenser fan units. I took an OSHA 10 hr safety course. I’m familiar with Air compressor repair, Gear box repair, and electrical repairs; I’m also familiar with Using volt meters, micrometers, and calipers; I worked with 110 volts thru 575 volts and repaired light ballasts and electrical outlets - Ran PVC conduit and pulled wiring. Worked on hydraulics units also, forklift driving also. Writing up sales and repair tickets and parts counter sales Repair chain blocks come-alongs and electric and air hoist...

EDUCATION:

197*-****-** grade diploma, Washington High School

1977-1979 AVTS Night School Heating and Cooling

EMPLOYMENT:

February thru Present

Self Employed

- Repairing commercial power-tools. Installed ac condensor units. Control boards and blower motors and fan motors and inducer motors and humidifiers and 24 volts wiring and PMA accounts. Painting and plumbing. Building maintenance and cleaning.

April 2006-Feburary2007

Midwest Fastener

- Repaired all power tools and nail-guns.

- In charge of warehouse and delivery.

January 2004- March 2006

Electro Mech. Sales and Service

-Repair of single phase and 3 phase electric motors and DC electric motor.

-Also did service calls jobs on eight elevator motors.

May 2003-December 2003

Top Master: Maintenance Technician

- Repaired electric and cordless power tools and pneumatic and air tools and bldg maintenance.

- Repaired all lights, ballasts, plumbing, and painting.

June 2002-May 2003

Century Personnel

- Building Maintenance and 1 phase and 3 phase motor repair.

- Ran PVC conduit from dip tanks to main plc panel and pulled wire.

- This was a complete rebuild job. This was a temp job after plating shop

had a fire - 24volts 11volts and 230volts.

March 2001-June 2002

Electric Service Co.

- Repaired 1 phase and 3 phase and DC Electric Motor and Tool Repair.

January 1985-2000 Retired

US Postal Service

- Letter Carrier

May 1977-1985

Klemp Electric

- Repaired single phase and three phase electric motors and all types of power tools. And DC electric motors

Contact this candidate