ALDWYN WOLFFE JR
[**** SW SCOPE ST, PORT SAINT LUCIE 34953] [954-***-**** ] [*******@*******.***]
Objective To obtain a challenging position that will utilize my experience and expand my potential.
HARDWARE/NETWORKING: Utilized and a wide variety of NIC cards Hubs, patch
panels,repeaters, Ethernet & Token Ring cabling, Cisco routers and switches. IBM and Dell servers.
Desk Tops, Dell’s, IBM PS/2 , Gateways, Apple Mac’s & Sun solaris
Laptops, Toshiba, Dell, IBM Think Pads & Compaq Lites.
Printers, HP Laser Jet, Epson & Compaq.
Communication Internet, Explorer, Netscape
Desktop, Windows 98, 2000 XP, Vista, MS Exchange, Word Excel
Communication Other, Cisco routers
Experience SERVICE / FACILITY TECHNICIAN
12/09/2005 to 10/28/2011, AT&T, Margate, Florida
Install, rearrange maintain and remove customer wiring/cables facilities.
Troubleshoot and repair customer electronic equipment.
Knowledge of Networking LAN/WAN, TCP/IP
Voice experience Analog ,Digital and VoIP experience
Analyze trouble conditions and determine work to be done
Work on telephone poles and ladders, indoors and outdoor at homes or businesses
Use hand held computers to update work status and check new assignments
Spliced, repaired and installed copper wire on both underground and aerial locations
Repaired and installed fiber optic lines on both underground and aerial locations
Operated various fusion splicer ,TDR and OTDR machines
MAINTENANCE TECHNICIAN
01/15/2002 to 12/07/2005, TSA, Hollywood, Florida
Oversees the checkpoint on a daily basis
Scheduling an adequate number of screeners to provide efficient screening
Preventative maintenance all security equipment
Installed and test new machines to be used at the security checkpoints
Created and provided documentation for works in progress and completed projects
Worked with Engineers to develop test procedures and quality standards
Configuration and troubleshooting of hardware and software
ALDWYN WOLFFE JR
[4514 SW SCOPE ST, PORT SAINT LUCIE 34953] [954-***-****
ELECTRONICS TECHNICIAN
08/1996 to 11/2001, H& L ELECTRIC, Queens, New York
Analyze and Repair various types of revenue control system components
Diagnose and replaced network systems devices
Inspect unit for physical or liquid damage do to misuse
Perform rework and update software to current OEM standards
Strong networking & technical support skills was used in a on call environment
Conduct analyzes procedure improvement and time studies alongside Engineer.
Diagnose and isolate malfunction to component level with the use of schematic and troubleshooting guides
Perform functions associated with all calibration and analysis and troubleshooting of circuits, and electromechanical assemblies.
Utilize test equipment, PC workstation and tools such as DVM, Signal generators, oscilloscope, DC power supply, Fiber optic tester and solder and desolder workstation.
SENIOR TECHNICAL ASSOCIATE (Contractor)
09/1992 to 08/1996, LUCENT TECHNOLOGY, Mount Olive, New Jersey
Develop, test and support telecommunication hardware equipment
Support the research and development of ATM & Frame relay switching products
A+ installation, configuration & troubleshooting of software and hardware
Provided test report to support any data that was collected
Test and troubleshoot electronic assemblies and test equipment
Troubleshoot down to component level on all types of digital, analog, and RF circuitry
Troubleshoot and evaluate GSM, CDMA and TDMA products
Knowledgeable in the use of Spectrum Analyzer and other test equipment
Worked with Engineers to develop test procedures and quality standards
Managed a group of ten people on new products
Certified in Surface mount technology soldering techniques
Responsible for the training and development of new employees
Education New York City Technical University, Brooklyn, NY 9/93 to 12/97
B.S. candidate in Electrical Engineering Technology
Marcelle’s School of Electronics 06/89 to 08/92
Diploma in Electronic Technology
References References are available on request.