High School Quality

Andy Walter Beito

Experience: Wisegrahm, Fargo, ND (Jul 2011 to Nov 2011)

welder, starting pay $16.50 Ending Pay $ 16.50.

I finish welded John Deere 1870 sprayer wings with .045 pulse as well as quality I checked them.

Reason for leaving: I moved to Oregon.

D.M.I., West Fargo, ND (May 2011 to Jul 2011)

door welder starting pay $16.50 Ending Pay $ 16.50.

I positioned the base section in place, then I used a computer controlled torch to cut out the place for the door, after that was done I would use a grinder to clean up the area where the door fits up. Then I would fit the door in and heat it to 350 degrees and pack it with ceramic backing then I welded the doors in the base sections. It was about 32 passes with flux core wire. After its was welded I would use a plasma torch to back gouge the top then put about 15 passes on it. After it was welded I would blend the inside and out side with a grinder.

Reason for leaving: The work was five twelve hour shifts and it was to much for me.

Crary industries, West Fargo, ND (Feb 2011 to May 2011)

welder starting pay $16.50 Ending Pay $ 16.50.

I welded different components for their potato harvesters I used hard hire as well as duel shield corewire I welded mostly heavy material, all of the work was off of blue prints.

Reason for leaving: D.M.I. I thought was the second best to work in fargo.

Wisegrahm, West Fargo, ND (Nov 2010 to Feb 2011)

welder starting pay $16.50 Ending Pay $ 16.50.

I finish welded John Deere 1870 sprayer wings with pulse as well as quality checked them.

Reason for leaving: Crary paid the same for day shift as I was making for night shift so I went to day shift.

Case New Holland, Fargo, ND (Aug 2007 to Oct 2010)

welder 2starting pay $17.50 Ending Pay $ 21.75.

I welded C.E. Cabs for about a year with .045 hard wire. Than I welded A.G. frames for about three months. After that I welded A.G. cabs. I welded A.G. frames as well.

Reason for leaving: I had to take some time off but I didn’t have the points to cover the time I missed

O'Day tank and steel, Fargo, ND (Jan 2010 to Mar 2010)

welder starting pay $16.00 Ending Pay $ 16.500.

I finished welded 20'x12' tanks. I stick welded the top and bottom with 6011 rod, I put fittings in the tank, I cut out a hole for the door and put it in the tank, I pressure tested the tank at 3.5 psi.

Reason for leaving: I took this job because I was layed off from Case so when they called me back I went.

Arctic Cat, Thief River Falls, MN (May 2005 to Jul 2007)

welder starting pay $13.75.50 Ending Pay $ 15.25.

I started welding resonators. I welded them for three months. The company had a winter lay off. I stayed on and welded adv racks. I welded ATV racks for two months. Then I welded ATV frames. I welded ATV Frames for about seven months. I also welded service parts.

Reason for leaving: Case payed a lot more as well as their benefits were better.

Education: High School Diploma/GED

Roseau High School; Roseau, MN US; Jun 2002

Miscellaneous: 3g cert, over head crane cert, forklift cert, I can read blue prints, also use air arc, torch, common welding tools

Contact this candidate