Quality Control Assurance
Resume:
PAT J. AMATULLI
*** ******** **** ****** *****, NC 28429 ********.***@*****.***
OBJECTIVE To utilize my 25 years of experience in Quality Assurance/Quality Control disciplines including: First Article Inspection (CMM operator) and Metrology (calibration) per ISO 9001, ISO 17025 ANSI Z540.1, ANSI Y14.5 and AS9100 requirements. Creating SOP’s (procedures) and uncertainty budgets for accredited audits and proficiency testing. SKILLS & ABILITIES I have been involved in Quality Control areas of calibration and first article inspection in the aerospace, medical (Life Sciences) and manufacturing industry for 25 plus years. Most of that time in independent or third party commercial laboratory’s including, Transcat, Simco Electronics, CMM Technology, Advanced Measurement Labs, and Comtel Corporation. Assisted in Quality Audits and maintaining/creating company SOP’s and DOP’s including training and expanding SOA (Scope of Accreditation) to meet accredited body requirements for A2LA and ANAB. 15 years of experience as an Operational Supervisor at Simco Electronics calibration laboratory at the Los Angeles, California location. Budget planning, Capital Expenditures (Capex), Calibration coordinator for outside vendors and suppliers.
EXPERIENCE SENIOR TECHNICIAN/ SUPERVISOR TRANSCAT, FULLERTON CA. 12/12/21 - PRESENT
Responsible for daily lab operations of 6 technicians: assigning work, training and planning.
Daily bench experience with all attributes of Physical Dimensional equipment including torque, pressure, length, angular, high vacuum, force, Mass, Threads, temperature and Humidity, Optical and laser measurements.
Performing first article inspection on various fixtures using a Coordinate Measuring Machine (CMM) and ASME Y14.5 Geometric Dimensioning and Tolerancing practices.
PAGE 2
LEAD TECH/ OPERATION SUPERVISOR SIMCO ELECTRONICS, CHATSWORTH, CA.
12/01/00 – 02/12/21
Lead technician/ Supervisor of Los Angeles Lab.
Responsible for daily lab operations of 15 technicians: assigning work, training and planning.
Responsible for creating uncertainty budgets and maintaining ISO 17025 quality requirements audits.
Interface directly with customers for compliance and capabilities as well as assisting the sales department for quotes and reviewing lists. Daily bench experience with all attributes of Physical Dimensional equipment including torque, pressure, length, angular, high vacuum, force, Mass, threads, conductivity/pH meters, surface plates, surface Roughness, temperature and Humidity, Optical and laser measurements. 25 years of experience as a first article inspector using a Coordinate Measuring Machine (CMM) and ASME Y14.5 Geometric Dimensioning and Tolerancing practices.
Writing and creating SOP’s for both calibration methods and laboratory practices in accordance with ISO standards.
CMM Technology / Field Service Technician
1994-2000
Calibrated, Repaired, Installed software on all various types of CMM’s
(Coordinate Measuring Machines) all over the USA.
Factory trained by Mitutoyo Corp/Chicago
EDUCATION
NORTHROP UNIVERSITY/ Inglewood, CA
GRADUATED FAA REGULATED TRADE SCHOOL FOR AVIONICS (AIRCRAFT ELECTRONICS)
CALIFORNIA STATE UNIVERSITY, NORTHRIDGE (CSUN)
PAGE 3
TQM (Total Quality Management) classes.
(Continuous Improvement, SPC, Customer Focus, DOE, JIT, Kazien) ASQC Certified Calibration Technician
A2LA training for creating uncertainty budgets per ISO 17025 requirement
GMP – Good Manufacturing Practice & Safety training Six Sigma Green Belt training.
REFERENCES UPON REQUEST
Contact this candidate