Electrical Engineer

`SOHAM CHAKRABORTY

** ******* **** ******** ** L*Y 2V7 · 647-***-****

*****.***@*****.*** · https://www.linkedin.com/in/soham-c-b5017898/ · Engineering graduate seeking to leverage experience of AutoCAD design, quality assurance, project management and integration of complex systems towards the success of an organization EXPERIENCE

JUNE 2022 – AUGUST 2022

QUALITY ASSURANCE LAB ASSISTANT, CALDIC CANADA INC.

- Supported shop floor QA monitoring of sanitation programs, production records, pest control, incoming shipments

- Supported the QA team in the development and implementation of HACCP and GMP programs and procedures

- Supported shipping department by providing the COA with delivery of product as per customer requests

APRIL 2019 – AUGUST 2019

ELECTRICAL TECHNOLOGIST, HAMILTON PLASTIC SYSTEMS LTD.

- Worked under senior electrician to build electrical panels for plastic loader machines

- Assisted with sanitation and organization of workshop and inventory

- Assembled and built plastic central system loaders and central vacuum pumps

- Repaired and refurbished older systems and plastic loading parts

- Assisted with setup and takedown of showcase during plastic company trade show JUNE 2014 – DECEMBER 2019

SHIPPING COORDINATOR, PARMALAT CANADA INC.

- Assisted maintenance team with operating and troubleshooting FANUC robot multipack machines

- Coordinated shift breaks and trained new employees on warehouse floor

- Executed production schedules, following specifications, correcting inconsistencies, updating, and writing SOPs

EDUCATION

GRADUATED: MAY 2023

BACHELOR OF ELECTRICAL ENGINEERING (B.ENG), LAKEHEAD UNIVERSITY 2

PROJECTS

STACK LIGHT INDICATOR, CANADIAN TIRE

- Worked with student technologist team to develop a design solution for a current sensor wired to a stack light indicator

- The clients (Canadian Tire) required a low-cost method to immediately detect the charging status of their automated guided vehicles (AGV) outside of software monitoring.

- Drafted and designed electrical drawings through AutoCAD, simulated design with LTSpice and then assembled with senior supervision

- Prepared related engineering design documents such as Single Line Diagrams, Wiring and Connections, and Bill of Materials

CAPSTONE PROJECT ENGINEER, LAKEHEAD UNIVERSITY

- Worked within a capstone team to design a system that could self-correct a stick equipped with reaction wheel motors to stay upright using PID and LQR controllers.

- Controlled the project using Arduino Rev3 Uno Chip and Po lulu Motor Shield. Programmed chip as two degrees of freedom PID Control System

- Worked within a limited timeframe of 1 year. When deliverables were not met, more meetings were scheduled to enforce deadlines and poll project team for additional assistance

- Wrote technical report and presented prototype along with fellow students to panel of experts.

- Prepared Gantt Chart, Budget, and Technical Specification in accordance with CSA and IEE electrical engineering codes

LANGUAGES, TECHNOLOGIES, AND COURSES

Languages: C, C++

Technology: Arduino IDE, MATLAB, Verilog, VDHL, Microsoft Office, AutoCAD Electric Relevant courses: Power Electronics, Engineering Economics, Project Management, Control Systems, Analog CMOS Design, Communication and PLC Network Systems, Programming Fundamentals, Operator Interface Design and Control REFERENCES AVALIABLE UPON REQUEST

Contact this candidate