CATIA, Ansys

KRISHANG KASHYAP

***A, Sector **, Panchkula · +918*********

********.*********@*****.***

To understand the depths of the engineering and to utilize that knowledge in the power generation and consumption sectors.

EDUCATION

JULY 2018

MASTER OF ENGINEERING, THAPAR INSTITUTE OF ENGINEERING AND TECHNOLOGY

JUNE 2015

BACHELOR OF TECHNOLOGY, AMRITSAR COLLEGE OF ENGINEERING AND TECHNOLOGY

JUNE 2011

12th, MOTI RAM SR. SEC. MODEL SCHOOL

JUNE 2009

10th, MANAV MANGAL SCHOOL

EXPERIENCE

APRIL 2019 – PRESENT

SPECTRAFORCE TECHNOLOGIES

RECRUITER

Source and recruit candidates by using databases, social media etc

Attracting suitable candidates through databases, online employment forums, social media, etc.

Assessing applicants' knowledge, skills, and experience to best suit open positions.

Perform job and task analysis to document job requirements and objectives JUNE 2016 – JULY 2018

THAPAR INSTITUTE

Performance investigation of VCR petrol engine at CR 8:1 and 14:1.

Worked on the exergy analysis of the pasteurization cycle of Verka milk plant.

Analyzed the compressor blades using SST k-ω turbulence model by varying the number of blades.

Investigated the rheological properties of coal water slurry.

Thermal modelling of a heat exchanger.

2

Investigated the flow properties and flowability of bulk solids as per ASTM D 2974-87 standards. Effect of inclusion of glidants on the flowability, and its effect on the tabletability property for mass production.

Interacting and inviting the industry officials for organizing of a short course on Design, Simulation and Troubleshooting of Bulk Solids Handling Systems.

Handling the TA work load and rectifying queries of the students. JULY 2014 – DEC 2014

AEROSPHERE

Learned to create part design, part assembly of various components over CATIA V5.

Structural analysis of the part/assembly using Ansys.

Performed the Modal analysis of a vibrating system, fluid flow (fluent) analysis of a duct.

Performed the explicit dynamics analysis of the chassis hitting a wall. MAY 2013 – JULY 2013

FEDRAL MOGUL

Worked in the plating department for plating an alloy on sleeve bearings.

Maintained the plastic housing to hold the sleeve bearings using friction welding.

Worked on repairing a non-performing hydraulic piston that is responsible for running the whole plating cycle.

Maintained the logs of the vendor invoice and customer invoice for an audit cycle. SKILLS

CATIA, ANSYS, NASTRAN, PATRAN

Workshop for Automotive Research in CRDi

Technology.

Fluent in Microsoft Office.

Workshop on emerging technologies in

Mechanical Designing in Manufacturing.

Participated in zonal round for ROBO Tryst –

2013.

ACTIVITIES

Understanding the physics behind various cosmological events. To learn about computer hardware and IT.

Contact this candidate