Hypermesh, Ansa, Nastran, Hyperview

RAMESH M Mobile: +919*********

Email: adh27g@r.postjobfree.com

ACADEMICS:

B.E in MECHANICAL Engineering in Maharaja Engineering College,(2017) Coimbatore. Aggregated with 64 %

Higher Secondary Examination in Govt Hr Sec School, kullanur (2013), Aggregated with 82%

SSLC in Govt Hr Sec School, kullanur (2011), Aggregated with 89% SOFTWARE SKILLS:

Hypermesh

Ansa

Nastran

Hyperview

WORK EXPERIENCE:

Current Company : HCL Technologies, Chennai as Member Technical staff,(Deputed to Ford Technical Center, Chennai)

Role : Cae Modeler

Previous Company : COPES TECH INDIA PVT LTD., BANGALORE Role : Cae Trainee Engineer (sep 2017 to Jan 2019) DOMAIN KNOWLEDGE:

Experience in modeling Plastic and BIW Components of automotive parts with good fundamental knowledge in Finite Elements Analysis

Knowledge in Interior Trims Subsystem assembly parts..

Knowledge in linear static analysis, modal analysis

Experience in clearing intersection and penetration

Knowledge on connections like rigids, spot weld, seam weld, beam, bar elements Projects done in Ford Technical center:

FE Modelling of interior trim parts:

Prepare fe modeling for ip console parts like substrate, top finish panel, air cool register,duct cover, display panel, defroster cover, storage box, glove box, switch bezels, console top panel,cross car beam parts, knee buster.

Door trim parts like substrate, map pocket, switch bezel, arm rest cover, ambient light cover,top roll,handle, handle cover, insert substrate.

Hard trim parts like A pillar, B pillar, C pillar, door scrf cover, rain sensor cover, d ring mechanism, seat belt cover, wire shield, back upper panel, Projects done in Copes Tech India Pvt. Ltd., Bangalore:

FE modelling of plastic components like seat backrest cover, lower trim, interior trim parts, exterior trim parts. front bumper, front fascia, motor plate .

BIW components like door inner panel,outer panel, rear floor, dash and cowl.

solid components like arm bracket,hanger bracket,wheeler rim, Training Project 1: Static Strength & Modal Analysis of Motor Bike Brake Pedal Stress analysis (SOL 101) was performed for two wheeler Brake pedal under normal/fatigue limit. Ultimate loads were applied to brake pedal and was verified for fatigue life with scatter factor 3 using SN (stress life) approach. Components natural frequencies (SOL 103) are also computed. FE Modeling of pipe, pad and lever was carried out using 2D quad elements and welds are modeled with 3D Penta elements. standard pre-processor & post processor FEM checks are performed. Training Project 2: Strength and Modal Analysis of an Automotive Exhaust Cold End Pipe Static strength analysis (SOL 101) of the Exhaust cold end (Flange, Pipe, and Hangers) is carried for self-weight i.e. 1g, bad road loads (5g-Vert, 3g-Lat, 2g-Axial). Natural frequencies

(SOL 103) of the assembly were computed. FE modelling is carried out with 3D Hexa elements for flange, 2D shell for pipe, and 1D CBUSH elements to represent isolator. Welds were represented using Hexa/Penta elements and bolts using rigid elements (RBE2). All standard pre-processor & post processor FEM checks are performed.

PERSONAL DETAILS:

Father’s Name : Munusamy

Date of Birth : 01-06-1996

Nationality : Indian

Permanent Address : #2/63, Gowrichettipatti, bikkampatti(po), Pennagaram (tk), dharmapuri (dt),

Tamilnadu. Pin: 636813

CONCLUSION:

“I hereby declare that the above information is true to best of my knowledge.” Date :

Place: RAMESH M

Contact this candidate