Manager Quality
Resume:
Scott A. Blank
Hinckley, IL ****0
*************@*****.***
Objective: Seeking a position as Quality Assurance Manager
Education: Aurora University, Aurora, Illinois
Middle Management Certificate
Related Course Work:
Waubonsee Community College, Sugar Grove, Illinois
Introduction to Heat Treat
Blueprint Interpretation
Statistical Process Control
Certified AS9100 Rev.D Auditor
Experience: Aurora Bearing Company, Aurora, Illinois
Quality Assurance Manager (May 2000- July 2020)
Instrumental in creating Quality Manual, Procedures,
Work Instructions and Forms to obtain ISO 9001 and AS9100
third party registration
Manage Supplier Preparation,Receiving and Quality Assurance Departments
Liaison for customer audits
Direct over site of Internal Audits and Corrective/Preventive Actions
Manage staff of eighteen, perform employee evaluations
Designated Manufacturers Inspection Representative acting on behalf of the Federal Aviation Administration
Quality Assurance Engineer (August 1999-May 2000)
Review customer contracts for quality requirements
Lead Auditor of Internal Audit Team
Audit and maintain Supplier Files
Teach product nomenclature to employees
Quality Assurance Technician (January 1997-August 1999)
Wrote Calibration Procedures and created forms still being used today
Performed calibration of gauging used throughout the organization
Created Purchase Requisitions and schedule out-sourced calibrations
Maintained all certifications and Records of Calibrations
Performed gage repairs
Quality Assurance Supervisor (July 1992-December 1996)
Directed the employees in the Quality Assurance Department
Authorized signatory to act on behalf of the Quality Assurance Manager
Performed employee evaluations
Quality Assurance Lead Person (July 1987-July 1992)
Recommended non-conforming product disposition to Quality Assurance Manager
Performed final inspections and returned goods analysis
Performed floor audits on machine operators
Quality Assurance Inspector (April 1984-July 1987)
Performed Receiving Inspection of component parts used in final bearing assembly
Approved first piece inspection of products made by manufacturing
Shipping & Receiving Clerk (February 1984- April 1984)
Pulled product from the shelves and performed shipments to customers
Created packing lists and prepared shipments
Scheduled truck lines for pick-up
Stocked shelves of finished product from Clean and Pack Department
Received products and generated receiving reports and logs
General Laborer (October 1980-February 1981)
Operated and set up a vertical milling machine
Used dial indicators and point micrometer to measure key characteristics
Contact this candidate