Chemical Engineering Mechanical

SHUBHAM

ACADEMIC PROFILE

Degree/Certificate Institution Percentage/CGPA Year

B-Tech Chemical Engineering IIT (BHU), Varanasi 8.43 2020 Sem I Sem II Sem III Sem IV Sem V Sem VI Sem VII Sem VIII 8.28 8.05 7.92 9.22 8.53 8.70 - -

CBSE (XII) DAV BSEB Colony, Patna 92.20 2016

CBSE (X) St.Karen's High School, Patna 95.00 2014

SKILLS

Software: MATLAB & Simulink, ANSYS, Pipe Flow Expert Soft Skills: Communication, Adaptability, Teamwork Area of Interest: Mass Transfer, Fluid Mechanics

INTERNSHIP/TRAINING

Summer Internship Dr. M.K.Mondal IIT BHU May '18-July '18 Enhancement of Carbon Dioxide mass transfer using functionalized nanoparticles Iron nano-particles preparation using wet chemical reduction method and their surface characterization(SEM and FTIR).

DEEA+HMDA+nano-particles in wetted wall column were used for absorption of Carbon Dioxide. Absorption time reduced by 42% with increment in absorption capacity by 5%(average). Industrial Internship Hindustan Zinc Limited,Debari May '19-July '19 Tracking and Improvement in Atmospheric Coolers Efficiency Efficiency and air flow rate of coolers were calculated and changes were observed for one week. Mechanical Structure of existing cooler was studied using ANSYS and Pipe Flow Expert. On basis of results, suggested a change in Pipe Support and Nozzle structure to decrease fouling and increase the efficiency of Cooling Tower Efficiency with reduction of wastage of Fan Energy. PROJECTS

UG Project Dr. R.S.Singh Jan '19- Ongoing

WGC(Weighted Geometric Center) approach for PID tuning of Industrial Boiler An arbitrary inverse model of Boiler was build using Simulink. WGC for different derivative gain were calculated. Unit Step Response of Closed loop system was compared between WGC and other settings based PID. Robustness Test was performed for the WGC based PID. MATLAB Project Oct '18-Dec '18

Design a PID controller for Distillation Column

Modelling of Distillation Column using mass balance equations. Reflux Ratio was manipulated to get distillate target composition within a range. Doublet input and its response were used to estimate the FOPDT model. PID controller was designed using IMC tuning correlations by FOPDT model parameters. CERTIFIED COURSES

Numerical Solution of PDEs

Petroleum Refinery Enginnering

A Hands-on Introduction to Engineering Simulations using ANSYS on edX POSITION OF RESPONSIBILITY

Event Coordinator OSMOZE'19

Organised and mentored 30+ students in Rachna,a simulation based event of Chemical Engineering. Designed a Problem Statement which focused on reduction of wastage and safety of products. Joint Secretary Social Projects Club

Founded and volunteered in the team of SkitsUp,which focused on empowering young orphans to think technically.

HONOURS AND ACHIEVEMENTS

Secured 2nd Position in Adhyayan,a case study event in Osmoze'17. RMO awardee sponsored by Homi Bhabha Centre for Science Education. Shortlisted for Final Round of Hindustan Unilever Ltd Camp Champ. T: 943******* E: *******.*******.*****@*****.**.** Address: C/O:Dayanand Prasad, Road No-1,Postal Park,Patna-800001

Contact this candidate