Sign in

Manager Sheet Metal

Warsaw, IN
15.00-$16.oo lowest and 18 highest
December 19, 2019

Contact this candidate


Chase Schwinnen

Ive been a Primer, router, CNC machinist, machinist,asst. Manager, roll tender, production worker, peir installer, and a metal fabricator also apolisher Warsaw, IN 46582


I'm a very hard Worker and take a lot of pride in my very dependable and learn very quickly. I have 2 young children that depend on me and the job I have just isn't cutting it. Authorized to work in the US for any employer

Work Experience

Metal fabricator

Warsaw foundry - Warsaw, IN

May 2019 to Present

Load heavy and hot iron castings off of the hot line. Then I have to snack said castings with a hammer to chip off the excess iron pieces, also grind and clean off any excess flacking or sand still on or in side of casting.

Production worker/ Roll tender

RR Donnelley/ lsc communications - Warsaw, IN

January 2014 to August 2019

Operating manual hoists clean up paper keep delivery machines running properly. As a roll tender I had to scan every new roll of paper into the database and the old out when finished with the roll or start a new job. Also maintain the press. As in read and adjust ink levels along with checking and refilling hydronic oil and maintenance as well. Oven Operator/ RTE

Maple Leaf Farms - Milford, IN

February 2019 to July 2019

1. Removing baked from the 3 ovens.

2. Push racks from oven down a ramp and drain duck grease. 3. As the first rack drains immediately take time and temp on all 3 racks In real time . 4. After all 3 are drained immediately push racks into freezer as last rack enters take cool down time. Lead Primer

Ameri-Kan - Warsaw, IN

July 2010 to January 2014

Maneuver dumpsters into position then lift with a balance hoist and prime said dumpsters lower hoist and manually maneuver them back onto track so it can brake it the oven's Metal Fabricator tech

Paragon Medical - Warsaw, IN


High school or equivalent in Ged

(Wchs) warsaw community high school - Warsaw, IN

May 2006 to July 2009


• Fabrication

• Sheet Metal

• Hard working (10+ years)

• Blueprint Reading (3 years)

• Tape measure (3 years)

• Grinding (4 years)

• Sanding (4 years)

• Manufacturing Experience

• Machining

• CNC Lathe


Forklift Certified

August 2019 to Present

1. Safe forklift operations

Additional Information

I can read blue prints, drive forklifts, and I'm not afraid to work hard or get dirty

Contact this candidate