Data Entry Line Lead
Resume:
Charlie Castillo
Fort Worth, TX *****
*******************@*****.***
I’m very dependable and hard working. I’m always on time and take any ot I can get. Work Experience
Technician
Medical Science Center - Fort Worth, TX
March 2023 to October 2023
As a technician I troubleshoot each oxygen unit we receive In and figure out why it’s not running purity. I then rebuild the compressors in the unit (if it needs rebuilt) or I’ll change out the sieves if over 10,000 hours. There are multiple other parts including pc boards that need to be resoldered. Once it reaches purity at 90 and above o then complete the paper work for the unit and send off to QA for final inspection. Line Lead
Genesys Aerosystems - Mineral Wells, TX
February 2021 to November 2022
I started off as an electronics technician and after 6 months got promoted to line lead. My duties in that position were printing out work orders for all 3 of my lines. Making sure the got completed on the due dates. I made sure all of my people were working and not distracted by anything. All products made were for airplanes so the needed to be final inspected by me before sending to QA. I made sure we had all parts needed to complete each monitor and radio. We had weekly line lead meetings and priority lists that we needed to go be and complete before said due dates. Electronics Technician
Antenna Products - Mineral Wells, TX
October 2016 to November 2020
• Inspect or test wiring installations, assemblies, or circuits for resistance factors or for operation and record results.
• Assemble electrical or electronic systems or support structures and install components, units, subassemblies, wiring, or assembly casings, using rivets, bolts, soldering or micro welding equipment.
• Adjust, repair, or replace electrical or electronic component parts to correct defects and to ensure conformance to
specifications.
• C l e a n parts, using cleaning solutions, air hoses, and cloths. P a c k a g e finished products and prepare them for shipment. R e v i e w work orders and blueprints to ensure work is
performed according to specifications.
M e l t and apply solder along adjoining edges of workpieces to solder joints, using soldering irons, gas torches, or electric-ultrasonic equipment. E x a m i n e seams for defects and rework defective joints or broken parts.
• H e a t soldering irons or workpieces to specified temperatures for soldering, using gasflames or electric current.
Education
GED
Mineral Wells High School - Mineral Wells, TX
Skills
• Electrical Experience
• Fabrication
• Assembly
• Equipment Repair
• Troubleshooting
• Soldering
• Blueprint reading
• Mechanical Knowledge
• Schematics
• Hand crimping tools (8 years)
• Hand held multi meter (8 years)
• Power supplies (8 years)
• Oscilloscope (5 years)
Certifications and Licenses
IPC-610 Certification
Contact this candidate