Power Electronics Software Engineer

DeepakKumar

***,****,*****-*,******-**, Panipat, Haryana-132103

Mobile : +91-816*******, E-mail: *****************@*****.*** Objective: A challenging career as a power electronics and embedded engineer. Key Skills:

Design, analysis, testing, and validation of non-isolated DC-DC converters; Circuit modeling and simulation using MATLAB-Simulink, PSIM, and LTspice.; Mathematical analysis using tools such as MATLAB, and Mathcad; Experience with HIL (hardware-in-loop) using TI controllers with Simulink integration.; PCB designing using Proteus, KiCAD and Altium Designer; Coding using MATLAB, Python, C, and C++; Embedded firmware development with 32-bit STM and TI controllers; Implementation of communication protocols such as UART, I2C, SPI and CAN; Use of latex and MS office tools. Education:

Degree CGPA/%age

Ph.D (Thesis Submitted)

(Power Electronics)

National Institute of Technology Delhi,

Delhi

2017-2024 8.57/10

M.Tech

(Power Electronics and Drives)

National Institute of Technology

Kurukshetra, Haryana

2009-2011 7.963/10

Bachelor of Engineering(B.E)

C.R.State College of Engineering,

Murthal, Haryana

2002-2006 69.59%

Experience:

Westhill Innovation Inc., Canada

Embedded Software Engineer

From June 2022

Working on the following projects:

-CAN communication between Inverter and Battery using STM32F407G Discovery Board.

-Software development for the Atlas inverter for speed control of compressor motor used for refrigeration.

-Development of mobile energy storage and DC fast electric vehicle charging station.

-Handling the project of setting of Off-grid solar-battery system for mining operation in Tanzania, South Africa.

-Procurement of flexi solar panels, high voltage battery packs, and inverters for solar trucker’s reefer units.

-Design of the single-line diagram and multi-line diagram for the electrical system of refrigeration system. Dronacharya College of Engineering

Gurgaon, Haryana

Assistant Professor

Feb 2016to Dec 2016

APIITSD India, Panipat, Haryana

Assistant Professor

Dec 2014to Jan 2016

National Institute of Technology Hamirpur, HP

Lecturer

Aug 2012to Aug 2014

GLA University, Mathura, UttarPradesh

Assistant Professor

Aug 2011to Aug 2012

-Teaching, Mentoring, Project handling and invigilation of labs. Projects:

Worked as Junior research fellow (JRF) in SERB-DST sponsored research project titled “Higher- Order DC-DC Converters for power management of DC Nano-grid in Futuristic Smart Buildings”.

Ph.D Project: Design, Analysis and Control of Battery Integrated converter for power management of low voltage standalone DC system.

Setup working hardware for the operation of dc-dc converters using C2000TMS320F28335 DSP peripheral board, Maximum power point tracking of photovoltaic panel using TERRA SAS ETS80 simulator, load voltage regulation, pulse charging/discharging of battery through PV panel and DC bus, single-layer PCB design for voltage sensor (LV25P), current sensor (LA55P) and dc/dc converters, Running the dc/dc converters in open and closed loop; Coding using code composer studio compiler and MATLAB integration for graphical interface.

M.Tech Project: Measurement of three- phase power supply system using MAXIM chip MAXQ3183 by SPI communication with the microcontroller P89CV51RD2. Setup working hardware for the energy metering for the measurement of power, voltage, current, and frequency, PCB design for the voltage sensor and current sensor in proteus software, LCD and Monitor display, coding for serial and SPI communication in KEIL C.

B.E Project:DC stepper motor control through laser using AT89C51 microcontroller Control the speed of DC stepper motor using light detecting resistor (LDR), muti-vibrator IC555 and driver IC ULN2003.

Accomplishments:

Published 3 conference papers and 5 journal papers before Ph.D. and published 4 conference and 3 SCI journal papers, and 1 book chapter during Ph.D.

Qualify the various competitive exams such as GATE, GRE, IELTS.

Receive MHRD scholarship for my master's and doctoral degrees. Hobbies:

Image and video editing. I've edited the video of t h e ICCCS2016 conference for the Dronacharya College of Engineering, Gurgaon.

Upskilling myself by learning new skills.

Professional Websites Links:

Google Scholar

https://scholar.google.com/citations?user=QsUb7BkAAAAJ&hl=en Linkedin Link

linkedin.com/in/dkaroraelectri

cal

Github Link

https://github.com/timothyaro

ra

Website Link

http://pythonarora.pythonanywhere.c

om/

Contact this candidate