Tristian Post

Electrician

Piñon Hills, CA

ad4h6r@r.postjobfree.com

+1-442-***-****

• Residential electrician 2010-2012

• Mig, Tig, Flux and Stick welding 2012-2016

• Equipment Maintenance technician aerospace 2016-2017

• Commercial, solar and industrial electrician 2017-2023 Authorized to work in the US for any employer

Work Experience

Journeyman Electrician

360 Industrial Services - Pittsburg, CA

April 2023 to Present

Wire and install fire alarm system for battery storage facility. Terminate low voltage terminal blocks, pull wire, install j box, and terminate Siemens smoke detectors. Journeyman Electrician

Ardent electrical - Blythe, CA

January 2023 to March 2023

Battery installation at solar plant. Disconnect dc power with 40cal suit on check dc voltage for residual current on buss bars. Lock out tag out. Ground out bus bar and install battery terminate positive and negative on batteries. Hook up terminals to bus bar from bcu. Electrician

Vos Electric - Mountain Pass, CA

February 2022 to January 2023

Mine site electrical work. Bending aluminum, rigid and pvc conduit. Installing fiberglass and aluminum cable tray. Reading prints to pull wire to hand stations, disconnects and start stop switches. Terminate devices and receptacles.

Electrician

Mhs electric - Ontario, CA

February 2017 to December 2021

Running rigid and emt conduit

3/4” -1 1/2”. weld unistrut support’s for conduit, jboxes And disconnects.Pull wire to feeder panels, devices and disconnects. Install bar lights with unistrut and all thread. Terminate hand stations, start stop buttons, disconnects and motors.

Maintenance Technician

MK Magnetics - Adelanto, CA

April 2016 to January 2017

Trouble shoot equipment, rebuild equipment, weld fixtures for magnetic parts, weld inconel rods inside nickel oven, replace bearings and other components on machinery. Check relays and bus fuses. Make sure all start-stop buttons are working properly by checking voltage when pushed down. Production Welder

FAB TECH - Chino, CA

May 2014 to February 2016

• Press brake operator

• robotic welder operator

• bearing and ball joint press Operator

• forklift operator

• reach & sit down crown shyster scissor lift

• Mig welding

• Tig welding

Welder and Fabricator

Solutions for blast - Pomona, CA

September 2012 to May 2014

• Repair sand blasters

• Welding repair

• Seal and gasket replacement

• On jobsite repairs

• Usage of cold saw, bandsaw & hand tools

• Forklift operator

Residential Electrician

Schamber Electric Inc. - Norco, CA

June 2010 to September 2012

• Reading Blue prints

• Layout, drill and Doty plates

• Label wire, Pulled home runs and circuits

• Installation of gain boxes, can lights, ceiling fans and exhaust fans

• Terminate plugs, switches, ceiling fans, can lights and exhaust fan

• Finish work, caulking indoor, exterior light fixtures, switches and cover plates Education

High school or equivalent

Skills

• Carpentry

• Electrical experience

• Millwright

• Welding

• Blueprint reading

• Fabrication

• Commercial electrician experience (2 years)

• Industrial electrician experience (4 years)

• Low Voltage

Certifications and Licenses

California Electrical training card

Present

MSHA

Present

Electrical Safety

Contact this candidate