Angel Soliz

Texas City, TX *****

ad0tez@r.postjobfree.com

+1-832-***-****

Willing to relocate: Anywhere

Authorized to work in the US for any employer

Work Experience

Electrician

Contech Engineered Solutions LLC - Freeport, TX

June 2022 to Present

Install instrument trey in new construction project pull wire terminate instrument heat race Electrician

ISC Constructors, LLC - Port Arthur, TX

April 2021 to May 2022

Install conduit and cable trey in unit for new construction project pull wire and terminate j boxes and instruments

Electrician

Ncw

November 2020 to February 2021

Commercial building install emt conduit for lights an rdu units and install determinant power Electrician

Amber

November 2019 to August 2020

Pull wire to mcc building and install conduit and terminate junction boxes and marshmallow cabinets

Electrician

S&b

March 2019 to October 2019

Run conduit and install new wire system in new construction site Electrician

ISC

August 2018 to February 2019

Run conduit from j-box to the instruments .:Terminate instruments and at the j-box:Read P.I.Ds to verify instruments and location conduit needs to be done.:Install lights and horns for the unit. Electrician

Bay Ltd

May 2018 to August 2018

Demo out burndown conduit and wire in the alky unit.:Run conduit and pull new wire to instruments and detectors.:Terminate j-box and instruments use phones to verify wire is good.:Verify with P.I.Ds for location of instruments

Electrician

Brown and root

February 2018 to May 2018

Work on temporary power in the unit

Install disconnects for power:Put up lights and bulbs in unit for temporary power. Electrical Technician

Yokogawa

March 2017 to January 2018

Walk down instruments in unit with P.I.D to verify model and serial number.:Calibrate instruments in the field and put in service using a 475 communicator.:Install heat tracers for analyzers throughout unit and terminate to control ax1 boxes.:Maintain analyzers for any electrical or instrument problems and maintaining temperature

gauges.

Instrumentation and Electrical Specialist

IES Engineering

June 2014 to February 2017

Cutover over instruments to new dcs system.:Calibrate instruments using 475, 789 communicators.:Run conduit for instruments and homeruns going to mcc.:Pull wire to mcc and and instruments.:Terminate instruments and loop check wires going into instruments Education

GED

Skills

• E & I

• Electrical Experience

• Calibration

• Blueprint Reading

• Troubleshooting

• Mechanical Knowledge

• Schematics

• Programmable Logic Controllers

• Mechanic Experience

• Low Voltage

• Assembly

• Hydraulics

• Distributed control systems

• Commercial construction

• OSHA

Certifications and Licenses

TWIC Card

OSHA 10

Contact this candidate